Whirlpool Dryer Cap Or Cover

This was actually one of the easiest fixes I’ve done. All that was required was to remove 3 screws to remove the broken part. I used a pair of pliers to remove the moisture sensors from the broken part to the new one. Read more

Ordered a new filter and filter holder Read more

I referenced the repair video. Very straightforward and easy. Only need 3 tools: 1/4 and 5/16 nut drivers and Philips head screwdriver. About 15 minute job. Surprising how much lint and dust build up inside the chassis, was able to clean that out too. Read more

Ordered new valve. Easy installation. Saved a service call charge (-; Read more

Replaced door Read more

There is no good diagram explaining how exactly these fit in. I had to do trial and error. The parts are quite delicate so I actually broke one trying to get it in. I would recommend ordering an extra or two. These need springs tonfit correctly. Luckily I saved the old ones...if you don't have them, it won't work. Unscrew the two screws on outside and two inside. You don't have to take whole thing out, just loosen. Look carefully and you can see the two little holes in the plastic where... Read more

Was an easy fix with the new part and instructions. Read more

I drilled old lock out and installed new lock box. This was the info your Tech had given me and as always your Techs are on top of all situations. This took about 15 minutes and it's back collecting money. Thanks for such quick and reliable service. The tracking info was a big help , keeping GM advised as to final repair , knowing when part would arrive. I again want to thank you for your reliable service and keeping me aware of where my part was and when I can install. Read more

Replaced broken coupling with new coupling Read more

Open dryer door. Remove four Phillip head screws that hold lint assembly together. Two inside and two on the outside. There is also a hex head screw behind the front panel. To get at it I removed the four hex heads at bottom of front panel and four star head screws on left side of front panel. I was able to get at it by pulling the front panel out as much as possible and and reaching from the side with small quarter inch socket. Remove lint assembly, vacuum out everything and replace with new... Read more

Took off the freezer door, took off the top hinge on the refrigerator door, replaced the handle, re-installed the top hinge and the freezer door. This is a two person job - one to remove the top hinge and replace the handle, while a second person holds the refrigerator door in place. Replacing the handle was easy. The most irritating part was figuring out what parts to order. The drawing of the refrigerator door (Drawing # 4) used to figure out what parts to order was not clear. I paid $8... Read more

Replacement parts fit perfectly. Read more

Replaced broken part. simple pop in place. Read more

I followed the instructions provided by customers that previously described how they made the same repair. In addition; I ended up placing a small piece of scotch tape on the door to hold the spring in place, while I tried to place the end of the door into the hole. The spring fell off the first few times that I tried assembling it, so the tape kept the spring in place. The biggest issue was trying to get my large hands into the tight spot, where the door needs to be inserted. Even after... Read more

Replaced heat pump door. Read more