Whirlpool Microwave Parts

I replaced the screen filter (by sliding it to the rear), and then removed the filthy charcoal filter. Then I slid in the new charcoal filter and replaced it with a new screen filter. I repeated the other side. A piece of advice: the screen filter (silver one) comes with one per unit, where as the charcoal filter came with two per unit. If I had known, I would have purchased one charcoal filter (as two come in a pack). In a way it was a win-win situation because I now have a charcoal filter for... Read more

Ordered your charcoal and stainless steel filters, checked out a YouTube video, et voila!! Slicker than a whistle! Thanks! Read more

Removed old filter and installed a new one. Read more

• Won't start

In addition to blown fuse; the fuse holder was melted at one end. Checked the unit to see if any part or wiring that would cause the issue, none was visible. Referred to wiring diagram included inside to identify components, including interlocks. All seemed functional. Bought replacement 20A fuse. Fuse holder no longer available so bought similar unit with 25A rating - little retrofitting. Put unit back together, and it's working so far. Wife is happy. Read more

I ordered the part from AppliancePartsPros.com. I received the part quickly; unscrewed the old door removed it and popped on the new door part and screwed it in. It took no more than 30 minutes to replace. I saved at least $300 dollars if I had to replace the whole microwave. Read more

I ordered a new magnetron and a new capacitor and after they arrived I set to work. I took plenty of pictures with my phone to remind me how the components came apart but it was pretty straight forward. Once the new parts were in and everything was reassembled the microwave worked good as new. The repair was less than a third the cost of replacement and no special tools are required. Just be careful to discharge the capacitor. This website is a great resource. Read more

I received the parts from parts pro within 3 days and everything fit perfectly nd all went well Thanks Parts Pro Wayne Mazur Joliet Il Read more

Replace fuse .latches and grille support kit Read more

It easily snapped into place Read more

I looked up the problem on the Appliance Pros forum and it sounded like the magnetron needed to be replaced. We looked up and ordered the part from Appliance Pros and replaced the magnetron 2 days later when we received it. It was not a difficult replacement but was tume consuming to take it down and remove the cover to get to the part. Within about 90 minutes, we had our microwave back on duty! Read more

3 screws on inside edge of door, then pried it off gently. Removed and cleaned the glass and put it in the new door frame. Put the new frame on the door. Read more

The replacement part fit perfectly. Read more

I replaced the keypad entry and it fixed the problem for 24 hours, but then it beeped and entered 0. But is much better than it was. I am an electronics tech and I know through the yrs 2000-2010 there were a rash of bad capacitors produced. I now believe a second board which has these capacitors is the source of the problem. I also believe the second board let voltage spikes through which slowly damaged the keypad board. My goal is to order the capacitors which cost less than a $1 each... Read more