Whirlpool Refrigerator Ice Maker & Related

Cracked or broken ice cube tray? This plastic tray restores manual ice-making in your refrigerator. Simple drop-in replacement, no tools required.

Ice not dispensing or partially ejecting? This refrigerator ice maker ejector arm pushes ice cubes from the mold into the bin. Quick DIY fix.

Fix ice maker not making ice or leaking with this complete assembly. Most DIYers complete installation in under an hour with basic tools and screwdriver.

Note: Per the manufactuer, this is an icemaker only. For the harness use part number W10508673 and for the shut-off arm use part number W11342242.

Ice not dispensing or auger broken? This refrigerator ice crusher auger transfers ice from bucket to dispenser. Moderate DIY repair in 30 minutes.

The Icemaker Assembly is an OEM part for Whirlpool refrigerators. It includes all the necessary components to replace or install an icemaker in your refrigerator, ensuring you can consistently produce and store ice efficiently

Symptoms of a failing Icemaker Assembly include:

• No ice production or very little ice being made
• Ice cubes that are smaller than normal or misshapen
• Leaking water in the freezer compartment
• Unusual noises during the ice making cycle, such as clicking or buzzing

Causes of a bad icemaker can include issues with the water inlet valve, freezer temperature not being cold enough, or mechanical failures within the icemaker itself, such as a faulty motor or an obstructed fill tube.

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Ice maker not working or frosting over? This protective cover shields the control module from debris and moisture. Easy 30-minute DIY installation.

Ice cubes stuck in tray or not releasing? This ice mold and heater assembly warms the tray during harvest to release cubes cleanly into the bin.

Ice bin cracked or warped? This container stores ice from your icemaker and guides cubes to the dispenser. Simple plug-and-play replacement part.

Ice maker not producing cubes or stopped working? This complete ice maker assembly restores automatic freezing, harvesting, and shutoff. Typical DIY repair.

Ice dispenser clogging or container rusting? This refrigerator ice bin catches and stores ice from your icemaker. Direct replacement takes 15 minutes.

Used to prevent over ice production in the ice dispensing bucket.

Ice won't dispense or bucket feels loose? This ice bucket assembly collects and stores ice, includes auger and crusher. DIY-friendly replacement part.

This dispenser arm replaces the detergent dispenser actuator assembly to restore proper detergent release in affected dishwashers. It helps ensure detergent is delivered at the correct time for better cleaning results. What it does:

• Acts as the actuator/arm for the dishwasher detergent dispenser door
• Triggers or releases detergent into the wash at the appropriate cycle stage
• Helps prevent detergent from remaining trapped in the dispenser
• Common symptom: detergent not dispensing or dispenser door failing to open

• One dispenser arm

• Disconnect power and water supply before beginning any repair
• Handle parts carefully to avoid damaging the dispenser housing or linkage
• Basic hand tools are typically required; follow OEM service instructions

Ice maker dripping or splashing water? A cracked or clogged fill cup spout disrupts water flow. This direct-fit part restores clean dispensing in under an hour.

Ice maker producing misshapen cubes or not freezing properly? This ice mold tray forms and shapes individual cubes in your refrigerator's ice maker assembly.