Whirlpool Refrigerator Parts

At first my epoxy glue job worked for about three years, but finally gave out. The handle broke at the top where it screws to the door. The part to fix it was ordered from AppliancePartsPros.com and it arrived in a few days. It was intact and installed easily—good as new. The only issue with the part is the cost. It is a piece of plastic that shouldn’t cost $150. That’s 20% of the cost of the refrigerator! Read more

Replaced the icemaker Read more

I found the part I needed and purchased. Read more

First had to clean inside the empty freezer, that was the hard part. removed old gasket and cleaned inside the track in the door. had the new gasket well warmed and in the right shape. put new gasket in track. seating it firmly. It was very easy. I did watch a couple of online videos to get the general idea of what it detailed. While I was at it I cleaned the coils with the brush I also bought with the gasket, worked great. all in all if you get organized before hand and take your time,... Read more

• No heat or not enough heat

I ordered the parts through AppliancePartsPros.com. They were delivered the next day. I installed them and the dryer works great. Read more

Easily removed the old gasket and the new gasket was the exact size and snapped into place. Read more

Replaced water reservoir that had become contaminated with ??? Also had to replace the water filter, because the water contaminated it also. Cost was about $150, for two filters and the reservoir. The first filter was replaced because I did not know the reservoir was contaminated, and no water was coming out of the dispenser. Since the water in the ice maker did not come through the reservoir, there was no smell or contamination there. The new filter enabled water to come through the dispenser,... Read more

Replaced icemaker and shutoff arm. Easy project. Read more

Take off freezer door and tried to take off top shelf. Never got shelf off. Made it more difficult but got it replaced. Read more

Replaced water inlet valve. Read more

The video was very helpful, but my KitchenAid model required slightly more steps. Only the two screws in front held the filter housing, same as the video shows, but it has to be removed from the rear. My model did not have the wire brace, only the two front screws held the housing. Shut the water off and pull the electrical plug. Remove the two screws holding the filter housing in the front. Remove the lower panel in the rear at the bottom of the refrigerator. Remove the two screws holding the... Read more

Replaced refrigerator thermostat that I purchased from Appliance parts pros and now working like brand new. Read more

I ordered the part from you and removed the damaged board and replaced it with the new board. It now works perfectly. I took all of about ten minutes. Thanks so much! Read more

Easy off easy on. Watched video on your web site. Read more

Found the part on your site, was easiest to use, ordered it and replaced it. Read more

All this occurred after our utility had to cut off our water for 2-3 hours. We almost ordered a new ice maker, but thankfully someone had their repair story posted. Based on that story, we ordered a new ice maker supply line and a new water inlet valve for our Kitchen Aid refrigerator. After turning off the water to the refrigerator we noticed that the water supply line had almost burst right above the ice maker, so we thawed that out with a hair dryer, then replaced that line first. Removed... Read more