Parts for Thermador PDR366ZS: 18 - Griddle Assembly Parts

This is an overflow drip tray designed to catch liquid spills and boil-overs inside the range or oven cavity, preventing them from reaching internal components. It sits beneath the cooking area and collects excess moisture or grease. Replace this tray if it is cracked, warped, corroded, or no longer sitting flat, which could allow liquids to leak onto electrical parts below.

This heat shield is a replacement protective panel that helps direct and block heat away from surrounding components to reduce heat damage and maintain safe operation. It's a simple, durable part used where heat management is required. What it does:

• Protects nearby components from direct heat exposure and radiant heat
• Helps prevent discoloration, warping, or premature wear of adjacent parts
• Can reduce heat-related odors or smoking that result from nearby hot surfaces
• Restores proper clearance and airflow paths disturbed by a damaged or missing shield

• Disconnect power and gas before beginning any service
• Handle with care—edges may be sharp; wear gloves and eye protection
• Secure using existing fasteners or OEM-specified hardware; do not overtighten

This replacement cover is a molded plastic access cover that protects internal components and helps keep controls and wiring free from debris. It restores a finished appearance and secures parts behind the appliance panel. What it does:

• Shields switches, connectors, and internal wiring from dust and accidental contact
• Keeps moving parts enclosed to reduce snagging or foreign-object intrusion
• Restores a clean exterior where an original cover was cracked or missing
• Stops minor drafts or light moisture intrusion at the covered opening

• One molded plastic access cover

• Designed for user installation; remove power before accessing internal areas
• May snap or screw into place—retain any original fasteners for reassembly
• Inspect surrounding clips or mounting tabs and replace if damaged

Bulkhead elbow fitting that connects gas lines in your range or cooktop. Replace if cracked, leaking, or damaged to restore proper gas line connections.

This solenoid valve controls gas flow to your range's griddle burner by opening and closing when activated by the control board. It ensures safe gas delivery and proper flame control for even cooking. Replace if your griddle won't light, has weak flames, or if you smell gas near the griddle area.

This compression sleeve forms the sealing ring for a 5/16-inch tubing compression joint, restoring a watertight connection when used with a matching compression nut and fitting. Ideal for stopping leaks and restoring reliable water lines. What it does:

• Creates the compression seal on 5/16" tubing when installed with a compatible compression nut and fitting.
• Stops leaks or drips at compression-style water connections.
• Used on appliance water lines (ice makers, water inlets) and other 5/16" tubing joints.
• Replaces worn or damaged sleeves that fail to hold a tight seal.

• Shut off the water supply and relieve pressure before working on water lines.
• Inspect and cut tubing squarely; slide the sleeve onto the tube before threading the compression nut and fitting.
• Tighten the compression nut per the fitting manufacturer's instructions and check the joint for leaks.
• Replace the sleeve if damaged or deformed.

Seals 3/8-inch tubing in compression fittings for gas ranges and grills. Replace when leaks occur to restore a tight, drip-free connection. Verify fit.

Burner won't light or clicks continuously? This spark ignition module generates the voltage needed to ignite gas burners. Moderate DIY repair.