Bolens Parts

Fastening screw for lawn mowers, snow throwers, and trimmers. Secures components together. Replace if stripped, corroded, or missing during repairs.

Carburetor insulator gasket for gas line trimmers. Sits between carburetor and engine block. Replace if cracked, warped, or missing to prevent air leaks.

Thrust washer for lawn tractors and garden tractors. Replaces worn, cracked, or missing washers in engine and drivetrain assemblies. Essential hardware.

Attaches to the back of your walk-behind mower deck to prevent grass and debris from reaching the operator. Replace if cracked, broken, or missing.

Replace a broken torsion spring causing handle slack or engagement issues on your lawn mower. Common DIY repair restores proper tension and operation.

Fuel return line hose routes excess fuel from the carburetor back to the tank. Replace if cracked, brittle, leaking, or damaged to prevent fuel loss.

Replacement bail bar for walk-behind lawn mowers. Installs on the upper handle to control engine operation. Replace if cracked, bent, or broken.

Metal blade support spacer that mounts between the mower blade and bolt. Secures the blade to the deck base. Replace if worn, damaged, or missing.

Hinged mulch plug assembly for walk-behind lawn mowers. Replaces worn or broken mulch covers. Includes metal hinge. Installs in place of discharge chute.

Replacement oil drain plug for outdoor power equipment engines. Installs in the oil pan to seal the drain opening. Replace if stripped, cracked, or leaking.

Replacement torsion spring for lawn and garden equipment engines. Creates tension between levers and components. Replace if broken, overstretched, or distorted.

Fastener pin that secures nuts and bolts in lawn mower engines and assemblies. Replace if bent, missing, or damaged during maintenance or repair work.

Replace your snowblower's wheel assembly if the tire is worn, cracked, or damaged. Includes rubber tire and metal rim for proper support and mobility.

The exhaust systems on lawn and garden equipment are just as important as those on a vehicle. They need a good seal to prevent a leak between the carburetor and the exhaust tube, which would allow air leakage that could cause performance issues and loud noise. Over time all exhaust gaskets deteriorate and require a full replacement. It is relatively easy to replace an exhaust gasket and requires only the use of screw drivers, a socket set or a wrench set depending on the device being service. Replacement components such as sockets or screws may also be required during this repair. The gasket surfaces should be cleaned and fully dried before being installed between the carburetor and the exhaust tube. This exhaust gasket works with Toro, Simplicity, Murray and Briggs & Stratton lawnmowers, generators, snowblowers, wood chippers, and lawn tractors. It also works with equipment made by Craftsman, Husqvarna, Cub Cadet, Poulan, Wheel Horse, MTD, Ariens, and more.