Parts for Amana YNED7200TW0: 03 - Bulkhead Parts

Color: gray. Measures about 13 inches wide by 11-1/2 inches high.

This sensor plate is located inside your dryer and detects the moisture level of your clothes as they tumble against it, signaling the dryer to stop when the load is dry. It allows the dryer to run on automatic dry cycles rather than fixed time, protecting your clothes from over-drying. Replace this part if your dryer stops too early and clothes come out damp, or runs too long and over-dries every load.

Dryer won't heat or start? A failed thermostat breaks the heating circuit. Common DIY fix—test for continuity with a multimeter. Typical repair time: 30-60 minutes.

Dryer not heating? This complete heating element assembly fixes no-heat issues. Includes element, heater box, and thermal components. DIY repair.

Fix a dryer that won't heat with a new heating element. Common causes include broken coils or cracked ceramic. Moderate DIY repair with video guide.

Dryer won't heat or overheats? A faulty thermostat fails to regulate temperature. This common repair restores reliable heating in 30-60 minutes.

Dryer not heating or staying cold? This heating element restores heat output. DIY repair typically takes 30-60 minutes with basic tools and instructions.

Dryer runs but won't heat? A blown thermal fuse is the most common cause. This overheating safety device protects your dryer's heating system. DIY repair.

Flat metal washer that sits under fasteners to distribute load and protect surfaces. Replace worn, missing, or corroded washers during repairs.

Replacement drum support roller for dryers. Mounts on the axle to support the drum and enable smooth rotation. Replace if worn, cracked, or noisy.

Tapping screw for refrigerator assembly and panel mounting. Replace when stripped, missing, or damaged during repairs or cabinet disassembly.

The Thermistor is an OEM part for Whirlpool dryers. This part measures the temperature inside the dryer drum and sends this information to the control board, which regulates the heat to ensure efficient drying.  

Causes of a bad thermistor can include regular wear and tear, exposure to high temperatures, or electrical faults.

Symptoms of a bad thermistor include:

• Dryer not heating or overheating
• Clothes taking longer to dry
• Inconsistent drying performance
• Error codes related to temperature issues

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Self-tapping screw for appliance assembly and repairs. Secures handles, bins, shelves, and components. Replace missing or stripped screws during moves or repairs.

Wire harness not included. For harness use part number 35001164.

Self-tapping screw for appliance assembly and repairs. Secures handles, bins, shelves, and components. Replace missing or stripped screws during moves or repairs.

Fix loud grinding or squealing noises from a broken blower wheel. Restores proper airflow in your dryer. DIY-friendly repair, typically 30 minutes.