Parts for Kitchenaid KSM7586POB1: 02 - Case, Gearing And Planetary Unit Parts

Covers and protects the attachment hub on your stand mixer. Replace if the original cap is cracked, missing, or worn for a finished look and protection.

Replacement mounting screw for stand mixers. Secures internal components and housing parts. Order a new screw if yours is stripped, missing, or damaged.

Factory replacement screw for stand mixers. Secures panels, brackets, and internal components. Replace lost, stripped, or corroded hardware for proper fit.

Replacement 8-32 x 5/8 mounting screw for securing internal panels, brackets, and components in stand mixers. Restores tight fit if original is missing or stripped.

Mixer stops under load or won't run? This motor restores mixing power. Requires housing disassembly and pin removal. Moderately difficult repair.

Replacement mounting screw for stand mixer panels, brackets, and trim. Secures internal components to keep parts aligned. Replace if missing, stripped, or rusted.

If your mixer won't start smoothly or speed settings aren't accurate, this speed control board regulates motor power. DIY-friendly replacement.

Small but critical: this groove pin locks the planetary/drive assembly to the mixer shaft so the beater is driven firmly and wobble-free. Replacing a bent or sheared pin restores solid, reliable mixing.

What it does

• Secures the planetary to the drive shaft to transmit torque
• Helps fix beater not-turning, slipping, or intermittent drive
• Reduces wobble or knocking from a loose planetary
• Replaces pins that are bent, mushroomed, or missing

What’s included
One groove/retainer pin (sold individually).

Install notes

• Unplug the mixer; work on a padded surface
• Support the planetary; drive the old pin out with a small punch
• Align holes and tap the new pin in until seated flush—don’t overstrike
• Inspect the planetary and shaft holes for elongation; re-grease if opened

Mixer won't turn on or keeps losing power? This power cord restores electrical connection to your stand mixer. Direct-fit part takes 15-20 minutes.

Retaining clip secures mixer components in place. Replace if cracked, rusted, or missing to restore proper assembly and stability of internal parts.

Washer spacer insulates and protects gears in your stand mixer's planetary system. Replace when gears become loose or noisy. Confirm fit with your model.

Fix a stand mixer that won't turn beaters or rotates unevenly. This planetary pinion gear restores smooth rotation when teeth are worn or stripped.

Mixer makes growling noise but beater won't spin? This steel retaining pin locks drive components in place. Moderate repair; disassembly required.

Flat metal washer that acts as a hardware spacer in stand mixers. Distributes clamping force where screws or bolts secure components. Replace if worn or missing.

If your mixer beater stopped spinning or spins loosely, this agitator shaft assembly transfers motor power to turn attachments. Moderate DIY repair.

Mixer making noise or shaft loose? This retaining ring locks gears in place on the drive shaft. Moderate DIY repair with snap ring pliers required.

Replacement mounting screw for stand mixers. Secures panels, brackets, and components to the frame. Replace if stripped, lost, or corroded.

If your stand mixer components are loose or misaligned, this grooved retaining pin secures parts together for smooth, quiet operation. Easy fix.