Parts for Ge JGP962SEC1SS: 02 - Control Panel & Cooktop Parts

Rubber foot that attaches to the bottom of cooktop grates. Replace if cracked, worn, missing, or loose to prevent grates from sliding and scratching.

Color: Matte Black

This is a double burner grate. The grates on a gas stove offer protection to the actual burner portion where the flames originate.Grates on a gas stove can become damaged through heavy impacts, rust, or other elements. Failure to keep them clean on a regular basis can also lead to permanent damage. Using certain pots and pans that aren't recommended for the surface could also be a cause of premature wear. Wear gloves when installing this part and be careful not to damage the burner eyes or stovetop. After removing the old grates, prepare the new ones by locating the slots the grates fasten to. Input the outer corners of the grates into these slots and slowly lower them down, making sure they're lined up evenly.This GE double burner grate is a genuine OEM replacement part sourced directly from GE. The grate is only available individually and does not include other parts or the original appliance. This product is compatible with GE brand gas stoves.

This machine screw is an authentic OEM replacement part sourced directly from the manufacturer. It is used in securing the burner head to the gas range top so that it can be used for cooking. If the burner head becomes loose or the screw is missing, it should be replaced. For safety reasons, the burner should not be used until this screw is replaced; the burner head could shift during cooking and lead to a fire. To start, disconnect the gas and power from the stove to prevent accidental ignition of the burner. Make sure the burners are not hot. Remove the burner grate and burner cap from the burner that is missing a screw. Install the new screw in the hole and tighten it with a screwdriver. Put the burner cap and burner grate back on the stove and reconnect the gas and power. Periodic inspection of the burner heads and all associated screws and parts on the stovetop will prevent accidents and keep the stove working correctly. This screw is a silver, metal part that is sold individually. It is designed for use in gas rangetops manufactured by General Electric and Hotpoint.

Burner won't light or clicking with no spark? This igniter creates the spark to light gas burners. Easy press-fit installation takes 15 minutes.

Burner base for gas cooktops, secures to cooktop surface and holds igniter assembly. Replace if cracked, broken, or damaged during repairs.

Burner base installs beneath the burner cap on gas cooktops. Replace if cracked, warped, or dome-shaped to restore proper flame coverage and alignment.

Approx 3 inches in diameter

Foam seal tape creates an airtight barrier between your cooktop and countertop, preventing spills from dripping into cabinets. Replace when worn or gaps appear.

Note: The part is approximately 4" in diameter.

Small

Note: The part is approximately 2-3/8" in diameter.

Seals burner assembly to cooktop surface, preventing gas leaks and ensuring proper ignition. Replace if cracked, brittle, or damaged during cleaning.

Seal for cooktop control knobs that prevents cleaning fluids and spills from entering the dial area. Replace when worn or cracked to protect controls.

Specially formulated cleaner for ceramic glass and smooth cooktops. Removes cooked-on food, grease, and spills without scratching. Verify fit by model.