Crosley Dishwasher Parts

This replacement part is a dishwasher pump and motor assembly. The dishwasher pump and pump motor circulate water through the dishwasher's spray arm. When the spray arms aren't spraying properly, this could mean that it's time for a new pump and motor assembly. Luckily replacing this part is a relatively simple process.Start by making sure the dishwasher is unplugged. After that shut off the water supply going to the dishwasher. Then disconnect the drain line from the garbage disposal or sink drain. Open the dishwasher door and pull out the bottom dish rack. Remove the upper dishrack from its track. Release the spray arm on the bottom of the washer. Then proceed to release the feed tube clips. Using a nut driver remove the bottom access panel and tow panel. Pull them out to remove them. Remove the power cable from the junction box, and disconnect the supply line from the inlet valve. Proceed to pull the dishwasher out of the counter. Tilt the dishwasher on its side and pull the hose from the drain pump. Remove the wire harness from the pump. Disconnect wires from diverter motor and circulation motor. Once complete, proceed to tilt the dishwasher upright and remove the pump and motor assembly from the bottom of the dishwasher. Replace with the new assembly.This replacement part is compatible with Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Sears/Kenmore brand dishwashers.

This chopper assembly replaces the food-chopping component in compatible countertop food processors, restoring even chopping and diced results. It helps get blades turning and keeps food processing performing as intended. What it does:

• Spins and chops food inside the processor bowl for consistent results
• Restores proper cutting when chopping is uneven or not happening
• Helps eliminate food buildup that causes noisy or inefficient operation
• Works with the existing drive coupling to transfer motor power to the blades

• Disconnect power and remove the processor bowl and lid before servicing
• Handle blades carefully — they are sharp; wear cut-resistant gloves
• Ensure the part seats fully on the drive coupling and locks into place before use
• Test operation with small amounts of food after reassembly; stop immediately if unusual noise or resistance occurs

This replacement spring provides the tension and return force needed for proper movement of a spring-loaded appliance component. Use it to restore smoother operation and consistent positioning where the original spring has worn or lost tension. What it does:

• Supplies tension and return force for hinges, latches or other spring-loaded mechanisms
• Helps restore proper movement and alignment of parts that sag, stick, or won't return to position
• Prevents excess play or slippage in spring-loaded assemblies when functioning correctly
• Works as a direct-fit replacement when the original spring is worn, stretched, or broken

• Disconnect power to the appliance before attempting any repair to avoid shock or injury
• Use appropriate hand tools and eye protection; springs may be under tension and can release suddenly
• Compare the old spring to the new one for length, coil count and end type before installation

Back

This bolt kit provides the replacement fasteners needed to secure appliance panels and components, restoring proper fit and reducing noise from loose parts. Designed to match OEM fastener sizes for an exact fit. What it does:

• Replaces missing or damaged bolts and screws used on appliance panels, brackets, or assemblies
• Restores secure mounting to stop rattling, vibration, or shifting panels
• Helps ensure components stay aligned for proper operation
• Provides the correct fastener types to match original mounting points

• Disconnect power or gas to the appliance before beginning any service
• Use the proper hand tools and torque carefully; do not overtighten fasteners
• Keep track of existing parts during disassembly and match fasteners to their original locations