Your privacy choices: We and our partners use cookies for analytics and ads. Decline all turns them off.
Privacy Policy · Do Not Sell or Share My Personal Information
Need Help?
Call
Replaces the burner igniter electrode and orifice holder assembly on gas range cooktops. Needed when the original is cracked, corroded, or broken.
It took a little longer then I was hoping but wasn’t terrible. If the burner is very old at all make sure to get the new screws. Both of mine snapped when trying to remove them. The new one works great. Read more
Replacement broiler pan set for ovens. Includes pan and insert to catch drippings during broiling. Order if your original is missing, warped, or damaged.
I ordered the brioler pan for my new stove from y'all it was a little small but that's the part number in the book that I got with the stoveyall did a great job fast shipping just what I ordered will by from again thanks Read more
Left-side oven door hinge that supports and controls door movement. Replace if hinge is cracked, broken, or door won't close flush, allowing heat to escape.
The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new Read more
Microwave won't turn on or has no power? A blown fuse is often the cause. This safety component protects against electrical surges and short circuits.
I have a Jenn-Air microwave that didn't turn on and had no lights. It just stopped working completely. I unplugged the unit and had to remove the rear cover using a *security screw kit* that prevents people from opening the rear panel. Once opened, I removed the fuse and testing it with an OHM reader to determine that the fuse went bad. But I also had to determine why the fuse blew and noticed a sticky oily substance under the Capacitor. I used a rubber glove and needle nose pliers to... Read more
The Dual Element Surface Switch is an OEM part for Frigidaire electric ranges and cooktops. It governs power distribution to the dual element.
Causes may be loose electrical terminals within the switch, defects from past power surges, or general wear over extended use.
Symptoms of a bad surface switch include:
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
I replaced both the large single element and the large dual element control switches. It appears the resistors were burning out. Problem seems to be fixed. Will know later when I do some simmering. Read more
Frames your range's ventilation opening. Replace if cracked, discolored, or missing. Installs around vent area for a finished appearance.
Had to order new plastic panel, scared to run the clean cycle again. Read more
Adjustable leveling leg that stabilizes and balances your range. Replace if cracked, broken, bent, or threads are stripped from wear or impact damage.
The problem was partly caused because the original legs were at full extension. The replacement legs were longer than the originals and were more secure at the needed length. One difficulty was that the threaded base plate where the legs screwed in had been damaged and had to be reshaped, I was able to reshape the sockets with some effort, to allow the legs to thread in, though one remained slightly angled. (A metal tool of some type which could be threaded in and used to bend the socket area... Read more
Horizontal oven door seal for top and bottom edges. Replace when worn to restore even heating and efficient baking. Hooks into slots on door frame.
A new ignitor was installed, and a new light switch was installed Read more
This bake element supplies the primary heat from the bottom of the oven during the Bake cycle. Replace it to restore proper preheating and even results when the original is burned out, damaged, or no longer heating. What it does:
It took 10 minutes and a screwdriver, remember to turn off power to the oven at the fuse box. By the way, I ordered the part at 1:30pm and received it at 12:30pm the next day using normal shipping, not bad. Read more
Burner won't heat or stays cold? This surface heating element restores steady heat to your electric range cooktop. Simple 15-minute DIY repair.
One of the heating elements of the stove was burnt. After removal of two screws under the ceramic glass, I replaced the 2500 w heating element (8 inch size). Read more
Replace your broken, cracked, or missing gas range burner control knob. This knob mounts on the control panel to adjust flame settings. Easy DIY fix.
I ordered new knobs to make the stove look like new! Looks great! I had a wonderful experience using your webpage and ordering the new parts. :-) Read more
Burner orifice regulates gas flow to your range burners. Replace if clogged with debris, corroded, or damaged to restore proper combustion and heat output.
Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more
Oven won't heat after self-clean cycle? This safety thermostat protects control components by shutting off power when temperatures exceed safe limits.
Replace your cracked, rusted, or clogged gas range surface burner. Mounts on the cooktop to direct gas flow for a steady flame. Easy one-screw install.
We took the old ones off and put the new ones on..it was easy to do ..I want to say that the girl (I think her name was Heidi) she was a big help ,she made sure that I had the right parts,I ask her to show me the picture to make sure that they look like the part ..She was a really big help. I did a survey when I ordered the parts to..Thank you for your help and the parts Anna P Read more
Replacement burner head for gas ranges and cooktops. Mounts over the orifice to distribute flame evenly. Needed when original is cracked or damaged.
Oven won't heat, display blank, or controls unresponsive? Replace the electronic control board. DIY-friendly repair, typically 30 minutes with basic tools.
Replaced with part No.AP4417276 electronic control board that we ordered from you and replaced it ourselves with your professional assistance. This has been an excellent experience with your company, and your return policy. Thank you . Read more
Opt-Out Request Honored
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.