Crosley Refrigerator Handle

• Door won't open or close

Ordered a new handle. Unscrewed two screws took the old handle off and put the new one on put the screws back in. It works great!! Read more

The door handle on our Frigidaire refrigerator had snapped into two pieces. The replacement parts were received within two days from AppliancePartsPros.com. My wife was able to quickly switch out the parts within 5 minutes. The unit looks as good as new. Read more

I ordered a replacement handle and screws. The process was very easy with the help of one of your "pros" who found all the parts needed and took my order. I didn't realize I was getting both a refrigerator door handle and a freezer door handle in one set, but now we have the freezer handle if we need it. Removing the old handle and installing the replacement was very easy. It looks great, in fact the replacement is metal, whereas the original was plastic, so it looks better than it ever did! Read more

No problem, 1 min to fix Read more

My Granddaughter fixed in about 5 minutes, she was proud and I was happy. Read more

Installation of the new handle after receiving a very timely shipment from appliance parts pros was simple. I lined up the top of the handle (hooked 90 degrees over the door) and then swung the handle down to meet the corresponding lower screw. The bottom slid and locked into place, then I screwed the top bolt in. Voila! Read more

Remove old handle: (2) large Phillips-head screws where it attaches to top edge of refrigerator door, back out (1)set screw lower end off handle- needs very small hex wrench. Retain screws: none supplied with new handle. Place new handle in place (need to back out the set screw on bottom of handle to slide it fully into place before tightening). Install (2) screws on top end, and snug the lower setscrew. DONE. Read more

First had to clean inside the empty freezer, that was the hard part. removed old gasket and cleaned inside the track in the door. had the new gasket well warmed and in the right shape. put new gasket in track. seating it firmly. It was very easy. I did watch a couple of online videos to get the general idea of what it detailed. While I was at it I cleaned the coils with the brush I also bought with the gasket, worked great. all in all if you get organized before hand and take your time,... Read more

Took the handles and screw covers out of package and in two minutes, all was installed and looking great. Read more

Replaced the handle. Read more

Replaced it Read more

Found the Block on your website. I was happy I didn’t need to order the whole handlebar instead. Read more

Replaced Handle. Read more

As easy as 1, 2, 3. Too simple to fix. Just screw in the screws. Read more

Put it on and tightened it quick and easy. Read more