Electrolux Dishwasher Clip Or Clamp

This hose clamp secures flexible water or drain hoses to fittings to prevent leaks and keep connections tight. It's a simple replacement that restores a secure seal and helps stop drips or loose hoses. What it does:

• Holds a rubber or plastic hose firmly to a barb or nipple to prevent leaks
• Restores a tight connection when original clamp is corroded, bent, or broken
• Helps eliminate water dripping, puddling, or intermittent leaks at hose joints
• Prevents hoses from slipping off during vibration or normal appliance use

• Disconnect power and shut off water supply before starting any repair
• Tighten clamp securely with pliers or the appropriate tool; avoid over-tightening which can damage the hose
• After installation, restore water and power, then check the connection for leaks

Red

A small replacement retainer clip that secures interior components and trim to keep parts aligned and stable. Fits specified Frigidaire/WCI assemblies and restores proper fit where the original clip is worn or broken. What it does:

• Holds panels, trim, or small assemblies in position to prevent rattling or misalignment
• Helps maintain proper spacing between components for reliable operation
• Commonly used where a snap-in plastic or metal fastener has failed
• Can stop noise caused by loose interior parts

• One replacement clip

• Designed for snap-in installation; remove power and any obstructing panels before replacing
• Inspect surrounding mounting surface and mating features for damage before installing
• Use gentle pressure to seat the clip; do not force or bend surrounding parts

This small snap-in clip secures trim, panels, wiring or small tubing to appliance chassis to prevent movement and rattling. It keeps components held in place so doors, panels and harnesses stay aligned and quiet during operation. What it does:

• Retains trim, insulation, wire harnesses or small tubing to the cabinet or frame
• Prevents loose panels, rattling noises, and interference with moving parts
• Keeps wiring routed safely away from heat or moving components
• Simple mechanical hold — no adhesives or fasteners required

• One clip

• Disconnect power before accessing internal panels or wiring
• Press clip into the matching hole/slot until it snaps; remove with needle-nose pliers if necessary
• Inspect the mating hole and surrounding tab for damage; replace if bent or broken
• Use the exact clip style for a secure fit; do not force into undersized openings