Electrolux Dishwasher Valve

The Water Valve is an OEM part for Frigidaire dishwashers. This valve controls the flow of water into the dishwasher, ensuring the correct amount of water enters the tub during the wash cycle.

Causes of a bad water valve can include mineral buildup from hard water, electrical failures, or wear and tear from regular use that affects the valve's ability to open and close properly.

Symptoms of a bad water valve include:

• The dishwasher not filling with water
• Leaking water around the valve area
• Inconsistent or insufficient water levels during cycles
• Unusual noises when the valve is in operation

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

The Water Valve is an OEM part for Frigidaire dishwashers. It is responsible for controlling the flow of water into the dishwasher, ensuring the correct amount of water is used during each cycle.

Causes of a bad valve can include mineral buildup, wear and tear over time, or damage from high water pressure or freezing temperatures.  

Symptoms of a bad valve include:

• Dishwasher not filling with water
• Water leaking from the valve area
• Irregular water levels during cycles
• Delayed or incomplete wash cycles

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This water inlet valve controls water flow to the refrigerator's ice maker and dispenser so your appliance makes ice and dispenses water reliably. Replaces a failed valve to restore normal water delivery and prevent leaks. What it does:

• Opens and closes to route household water to the ice maker and dispenser when signaled.
• Stops water flow when the fill cycle ends to prevent overfilling.
• Commonly replaces valves causing no water to the dispenser or ice maker.
• Also used when valve leaks or runs continuously.

• Turn off the refrigerator and shut off the water supply before starting work.
• Disconnect electrical connectors and water lines carefully; expect minor residual water.
• Inspect hose fittings and seals; test for leaks after installation.

This drain valve controls the flow of water out of the appliance to remove standing water and prevent overflow. Replacing a faulty valve restores normal draining and helps stop pooling or persistent drain error symptoms. What it does:

• Opens and closes to release water from the appliance drain path.
• Works with the pump/drain line to move water out during cycles.
• Common issues indicating failure: appliance won't drain, water pooling, or intermittent drain errors.
• Fits as the direct replacement component for the OEM valve in affected models.

• Disconnect power and turn off the water supply before starting work.
• Expect residual water in hoses; have towels and a pan ready to catch spills.
• Remove and replace using basic hand tools; keep clamps and seals secure to avoid leaks.

This flapper is a small plastic sealing flap that helps control and direct flow inside the appliance, restoring proper sealing and movement where the original flap is worn or broken. Replacing a damaged flapper helps stop leaks and restore normal dispensing or airflow. What it does

• Acts as a sealing flap to open and close a flow path or duct, preventing unwanted leaks or air transfer.
• Restores proper movement and alignment so dispenser, damper or valve mechanisms can operate smoothly.
• Worn, cracked or broken flappers can cause leaks, incomplete dispensing, or temperature/airflow problems.
• Simple wear or breakage is the most common reason to replace this part.

• One flapper

• High-level replacement; typically accessible by removing the cover or access panel where the flap is mounted.
• Inspect surrounding clips, pins or mounts for damage and replace if worn to ensure secure fit.
• Disconnect power and, if applicable, water supply before beginning work to avoid injury or leaks.