Electrolux Dishwasher Pump

This replacement pump moves water/condensate through your appliance so it can drain or recirculate as designed. Replacing a weak or failed pump restores proper water removal and helps prevent leaks, overflows, or nuisance shutoffs.

• Moves collected water from the sump/collection area to a drain hose or internal passage
• Maintains correct water level to prevent overflow conditions
• Common failure signs: water won't pump out, leaks near the base, or loud buzzing/grinding from the pump
• May trigger "bucket full," drain, or pump-related error indicators, depending on the model

• Disconnect power before servicing; allow unit to cool, and expect residual water in the lines or pan
• Note hose routing and wiring connections; transfer any clamps, grommets, or fittings from the old pump if reused
• Ensure hoses are fully seated and not kinked; tighten connections and check for leaks after reassembly
• Test operation after installation and water is expelled properly

This drain pump assembly removes water from the tub at the end of wash and rinse cycles, helping your appliance complete cycles and prevent standing water.

• Pumps wastewater out through the drain hose to the household drain
• A failing pump can cause slow or no draining, cycle interruptions, or error codes related to draining
• May also present as water left in the tub or an inability to start the spin/drain portion of a cycle

• Unplug appliance and shut off water supply before service
• Have towels or a pan ready—residual water will drain when hoses are removed
• Note wire and hose orientations before disconnecting; transfer any mounting hardware from the original if reused
• After installation, check for leaks and run a short drain cycle to verify operation

This circulation pump and motor assembly recirculates wash water through the spray arms so dishes get clean. Replace it to restore strong spray and quiet operation when the wash motor fails, becomes noisy, or leaks at the pump.

• Recirculates water from the sump through the spray arms during wash cycles
• Maintains proper water pressure and flow for effective cleaning
• Replaces a seized, weak, or noisy wash (circulation) motor
• Common symptoms: no spray or poor cleaning; humming or grinding from the pump; water leaking beneath the tub near the motor/pump

• Disconnect power and turn off the water supply before servicing
• Remove the toe panel; pull the dishwasher out as needed for under-tub access
• Place a towel to catch residual water; label/photograph wire and hose locations and transfer clamps from the original assembly
• Clean sealing surfaces; seat the assembly fully and test for leaks before reinstallation

Replacement pump assembly that moves water through the appliance to clear standing water and restore normal draining. Installs as a direct swap to address drainage problems and reduce water-related cycle interruptions. What it does:

• Pumps and removes water from the appliance to prevent pooling or overflow.
• Drives normal drain cycles so wash or rinse functions complete properly.
• Can resolve common symptoms such as water remaining in the tub, poor draining, or unusual motor/impeller noise during drain.
• Works with the appliance's existing hoses and wiring to circulate or discharge water as designed.

• Disconnect power and turn off water supply before starting any repair.
• Drain residual water from the appliance and be prepared for some spillage when removing the old pump.
• Label or photograph wiring connections before disconnecting; reconnect wires to matching terminals.
• Inspect hoses and seals while installing; replace any damaged clamps or gaskets to prevent leaks.