Electrolux Dryer Parts

This is a flexible seal that fits around the inner door glass of the dryer, creating an airtight barrier between the door panel and the drum area. It prevents heated air from escaping and keeps lint contained within the drum during drying cycles. Replace this gasket if you notice heat leaking from around the door, longer drying times, or if the seal is cracked, torn, or coming loose.

Rubber grommet cushions wiring, tubes, or panels in your dryer. Replace if cracked, worn, or missing to prevent chafing and reduce vibration noise.

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize

This is a replacement push button that fits on the appliance control panel and restores tactile control for a single function. It provides a simple, direct way to replace a worn, loose, or missing button so controls are usable again. What it does

• Replaces a damaged, cracked, or missing control panel push button
• Restores a firm tactile surface for reliable pressing of a single function
• Helps stop intermittent or unregistered button presses caused by wear
• Keeps the control panel looking complete and prevents accidental contact with underlying switches

• One push button

• Disconnect power to the appliance before any service to avoid shock or injury
• Typically snaps into the front of the control panel or slides onto a stem; keep track of orientation
• If access requires removing the control panel, keep screws and small parts organized for reassembly

Internal heat duct hose that routes hot air through your dryer drum. Replace if cracked, kinked, torn, or disconnected to restore proper airflow.

Replacement cap or cover for your dryer. Installs on the exterior or interior housing. Order a new cover if yours is cracked, broken, or missing.

Silver top panel for dryers. Replaces worn, scratched, dented, or discolored outer top covers. Restores cabinet appearance and finish.

Replace your dryer's heater plug insert if it's cracked, broken, or missing. This small component fits into the heater housing to secure connections.

Plastic cap cover for dryer installation. Replaces cracked, broken, or missing covers. Snaps into place to provide clean finished appearance.

This is a pipe component used in the internal plumbing or venting pathway of a dryer. It helps direct airflow or condensate within the appliance. Replace this part if it is cracked, damaged, or if you notice restricted airflow or moisture leaks inside the dryer cabinet.

Genuine screw fastener for securing dryer panels, brackets, and internal components. Replace when stripped, missing, or corroded to restore tight fit.

This is a genuine replacement screw used to secure appliance panels and components. It provides a simple, reliable fix for loose or missing fasteners so panels and parts stay properly attached. What it does:

• Fastens panels, brackets, or components in place to restore original fit
• Replaces missing or stripped screws that cause rattling or loose parts
• Matches OEM thread and head style for correct seating and torque
• Helps eliminate vibration-related noise by securing loose pieces

• One replacement screw as shown

• Inspect mating threads and clear any debris before installing the new screw
• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; avoid over-torquing which can damage threads or parts
• Disconnect power and follow appliance safety guidelines before servicing