Frigidaire Range / Cooktop / Oven Switch

Replace your range infinite switch if burners won't heat, overheat, or cycle improperly. Direct-fit control switch for smooth temperature regulation.

Range burner won't heat or stays on high? This infinite switch controls surface element temperature settings. Common fix for heat regulation issues.

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

If your range burner won't heat, stays on high, or cycles incorrectly, the infinite switch likely failed. This direct-fit part restores precise heat control.

Fix range display issues, unresponsive controls, or error codes with this control board assembly. Common repair for ranges that won't start or heat properly.

Oven won't heat to the right temperature or temperature control unresponsive? This thermostat selector switch restores precise temperature adjustment.

Range burner not heating or stuck on high? This infinite switch controls surface element temperature settings. Common DIY repair for heat control issues.

If your range burner won't heat, stays on high, or won't turn off, the infinite switch may be faulty. This moderately easy repair typically takes 30-45 minutes.

If your range burner won't heat, stays on high, or won't turn off, replace the infinite switch. This common repair takes 15-30 minutes with basic tools.