Frigidaire Range / Cooktop / Oven Switch

This is a push-button style switch used in the cooktop burner ignition system. It activates the spark module to ignite the gas when a burner knob is pressed or turned. Replace this switch if a burner no longer sparks when you attempt to light it, or if the igniter clicks continuously without stopping.

Fix a gas burner that won't light with this cooktop igniter switch. Common solution for spark ignition failure. Moderate DIY difficulty level.

This wiring harness assembly routes power and signals between the appliance control and electrical components so the unit operates reliably. It replaces a damaged or burnt harness to restore proper electrical connections and reduce intermittent faults. What it does:

• Connects controls, switches and motors to the main power and control board
• Restores interrupted circuits that can cause intermittent operation or component failure
• Helps resolve symptoms like lights, fans or motors not running or responding
• Replaces frayed, melted or corroded wiring that creates shorts or open circuits

• Disconnect power to the appliance before servicing to avoid shock or injury
• Handle connectors by the plug bodies; avoid pulling on wires
• Route and fasten the harness exactly as the original to prevent chafing or heat exposure

This is a latching switch that detects whether the microwave door is properly closed and secured. It is part of the door interlock safety system that prevents the microwave from operating when the door is open. Replace this switch if the microwave does not start, runs with the door open, or blows a fuse when the door is closed.

Replace your range infinite switch if burners won't heat, overheat, or cycle improperly. Direct-fit control switch for smooth temperature regulation.

Range burner not heating or temperature won't adjust? This surface element control switch regulates heat output. Moderate DIY repair in 30-45 minutes.

Burner won't heat or turn off? This infinite switch controls surface element temperature. Common fix when a burner stops working after replacing the element.

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

If your range burner won't heat, stays on high, or won't turn off, the infinite switch controls temperature. This part regulates surface element power.

Burner not heating or won't turn on? This electric range control switch restores power to stovetop elements. Straightforward DIY repair.