Frigidaire Wall Oven Parts

The Door Switch is an OEM replacement part for Frigidaire wall ovens. It is a component located on the oven door that detects when the door is opened and closed. The door switch works alongside the control board to regulate oven operations based on door position.  

Symptoms of a bad door switch can include:

• Oven failing to automatically go into bake or warm modes after door closure
• Interior lights not turning on when the door is opened
• Control buttons/display remaining constantly lit instead of dimming
• Oven not heating or functioning properly in different modes

Causes relate to normal wear over extended use as the door switch mechanism cycles with frequent door openings and closings. Moisture exposure or impacts could also degrade switch performance.

This OEM Frigidaire switch is compatible with Amana, Jenn-Air, KitchenAid, and some Electrolux wall oven models as well.

Burner cap sits atop the gas burner base to distribute flame evenly. Replace if cracked, warped, discolored, or missing to restore proper heat distribution.

Spacer that provides clearance between the range oven door handle and door surface. Replace if cracked, broken, or missing to ensure proper handle fit.

This is the bake burner tube located inside the bottom of the oven cavity in a gas range. It distributes gas evenly to produce a consistent flame for baking and roasting. Replace this burner tube if you notice uneven heating, weak or irregular flames, or visible damage such as corrosion or holes in the tube.

Replace a gas range burner valve that's broken, stuck open, or causing hard-to-adjust flames. Moderate DIY repair requires raising the stovetop.

Burner base mounts and houses the gas burner on your cooktop surface. Replace if cracked, discolored, or damaged to restore proper burner placement.

Replace a cracked, chipped, or missing burner cap on your gas range or cooktop. Restores a clean look and protects the burner assembly underneath.

Replacement control knob for your range. Presses onto the control shaft to select heat and temperature settings. Replaces cracked, stripped, or missing knobs.

Replacement grate foot kit for gas range burner grates. Includes 8 rubber feet and adhesive. Needed when feet are missing, cracked, melted, or worn.

This is a top burner gas valve that controls the flow of gas to a surface burner on a gas range. It connects to the burner control knob and regulates the flame from low to high settings. Replace this valve if a surface burner won't ignite, the flame is difficult to adjust, or you detect a gas smell even when the knob is in the off position.

Oven not heating or display blank? This electronic control board manages temperature settings and timers. Moderate DIY repair with basic tools required.

Burners won't light or no clicking sound? This spark module sends high-voltage pulses to ignite surface burners. DIY-friendly replacement fixes ignition.

Replacement surface burner head for gas ranges and cooktops. Distributes gas through precision ports for even flame. Needed when original is clogged, damaged, or corroded.

This is the gas supply tube that delivers fuel from the gas valve to the bake burner at the bottom of a gas range oven. It may include the orifice fitting that meters the correct gas flow for proper combustion. Replace this tube assembly if you notice uneven oven heating, a weak or absent bake burner flame, or if you detect a gas odor indicating a cracked or damaged supply tube.

Cosmetic overlay that covers and protects your range's control panel surface. Replace if scratched, cracked, peeling, or worn from kitchen use and spills.

Burner won't heat, stuck on high, or works intermittently? This cooktop burner control switch restores reliable on/off control. Easy DIY repair.