Need Help?
Call or text
Fix delayed oven ignition or gas odor with this spark electrode. Creates the spark that lights your oven burner. DIY repair in under 1 hour.
We ordered a new ignitor and it came in two days just as promised. The only problem that we experienced was that the leads on the new ignitor were to short. We were able to find enough slack on the oven end to make it work. The oven is once again working great. The video was a little off on what need to be done to disconnect the ignitor. We actually had to flip the oven over to get to the bottom. We could not access the connector through the back. Read more
Replacement control knob for your range. Presses onto the control shaft to select heat and temperature settings. Replaces cracked, stripped, or missing knobs.
Turned off the power, removed the back cover and out with the old control parts, then installed the new parts Read more
Oven won't heat or bake properly? A failed bake element is usually the cause. This bottom heating element restores even baking. Easy 15-minute DIY fix.
It's was easy to replace. Unplugged the oven from the wall, unscrew the two screws that hold the element to the back of the oven and pulled it away from the oven. Then just pull off the two wires at the end of the bake element. Install the new one in the revers order, easy. Read more
Oven broiler not heating or working? This broil element generates radiant heat at the top of your oven for browning and crisping. DIY-friendly repair.
Replaced the Broil element. Read more
Oven won't heat to set temperature or display shows error codes? This electronic control board manages bake/broil circuits and clock functions. DIY repair.
Black glass cooktop surface for electric ranges. Replaces cracked, shattered, or broken cooktop glass. Installs with screwdrivers in 15-20 minutes.
It is an easy job if you are good with screw driver and some general sense of things. Unplug the oven and than I opened the oven door and unscrewed two screws from bottom lift the glass door up and unscrewed the element coils total 4 screws there in total and pull the whole glass top out, removed the bracket from old glass top another 2 screws and 2 small brackets(snap on) from behind the glass top and put them on new one. slide the new glass top with back brackets into slot lift it up again to... Read more
If your range has no power or burnt plastic smell, the terminal block may be melted. This kit restores secure power connections. Moderate DIY repair.
Replaced the terminal block. Read more
Replace a gas range burner valve that's broken, stuck open, or causing hard-to-adjust flames. Moderate DIY repair requires raising the stovetop.
After turning off the gas and unplugging the electricity, I removed all the burners from the stove top using a 3/16" hex socket. Then used a 1/4" socket to removed two or three screws under each burner which hold the burner base to the bottom of the top panel. Then pulled all the knobs and removed the front panel which was held in by two Phillips screws accessible from underneath the panel. It helps to open the oven door to get at these screws. With the knob panel gone, I removed two screws... Read more
White adhesive clock overlay for oven control panels. Peels off and sticks on to replace cracked, worn, or faded overlays. Easy cosmetic upgrade.
My husband turned the oven to cook one night and there was a loud pop noise. After that there was no power getting to the control board and thus leaving my oven useless I watched the very easy to follow video posted on here associated with my part and I felt confident I would be able to make this repair on my own. I bought the control board as well as the new overlay (mainly cause I didn't want to try and peel off the old overlay and reuse it) the total time for my repair was less than 15... Read more
Small crown-style burner cap for gas cooktops. Sits atop the burner head to distribute flame evenly. Replace if cracked, chipped, or missing.
Replacement glass panel for oven door outer window. Restores clear viewing when cracked, shattered, or stained. Installs in door frame assembly.
Ordered glass and trim kit and replaced them myself. Read more
Meters gas flow to your range or cooktop burner for proper flame size. Replace worn, clogged, or missing orifices or when converting between propane and natural gas.
Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more
Burner won't heat, stuck on high, or works intermittently? This cooktop burner control switch restores reliable on/off control. Easy DIY repair.
Replaced the switch Read more
Wire rack for ovens. Provides a stable surface for placing dishes and cookware. Replace if discolored, warped, damaged, or no longer fits properly.
Special order size 22 1/2 by 14 1/2 oven racks. Ordered on Wednesday and delivered on Thursday!! Fantastic!! Read more
The Controller is an OEM replacement part for Frigidaire ovens. It acts as the brain of the oven, managing and regulating various functions such as temperature control, timer operations, and user interface.
Symptoms of a bad controller include:
Causes of a bad controller can include electrical faults, power surges, or component failure due to age or excessive heat exposure. Faulty wiring connections or damage to the circuit board can also lead to controller malfunctions.
This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore oven models.
I replaced the control board. Repair company wanted $395.00. I ordered the board for 140ish, 5 days later, 9 screws, 6 moduler plugs....working oven. The hardest part was pulling out the stove. Read more
Has three terminals.
When trouble shooting the problem I found that the light switch housing outer lip was broken allowing the switch to push through mounting surface behind the oven door. This is a slide in range so, I proceeded to pull the range away from the counter where I could unplug the power cord. Once the power was off like located the panel on the right upper side of the unit and removed the screws to allow access to the switch. I then unplugged the switch from the wiring harness and removed the damaged... Read more