Frigidaire Washer Switch

This is a pressure-activated switch that monitors the water level inside the washer tub. It signals the control board to stop filling when the correct water level is reached and helps initiate the wash and drain cycles. Replace this switch if the washer overfills, underfills, does not fill at all, or fails to advance through cycles properly.

This is a rotary or push-type temperature control switch that mounts on the washer's control panel and allows you to select the water temperature for each wash cycle. It controls the hot and cold water inlet valves to deliver the correct water temperature. Replace this switch if your washer only fills with hot or cold water regardless of the setting, or if the temperature selector no longer clicks into position or responds.

Washer not heating water properly or selecting wrong temperatures? This temperature switch controls water temperature settings. Common repair for temperature issues.

Fix a washer that overfills, underfills, or won't fill with water by replacing the water level switch. Simple repair that restores proper operation.

This rocker switch replaces a worn or broken on/off control for the appliance, restoring reliable manual control of the affected function. It's the direct-fit switch used where a small rectangular rocker actuator is needed. What it does

• Acts as the user-operated on/off control for the circuit it serves.
• Restores power control when the original switch no longer clicks or stays in position.
• Common symptom: switch feels loose, is stuck, or the circuit does not respond when the switch is operated.
• Uses the same mounting and electrical connections as the original to simplify replacement.

• Disconnect power to the appliance before attempting service to avoid shock.
• Access usually requires removing a control panel or console; keep track of fasteners and wire locations.
• Transfer wires exactly as removed; confirm firm terminal connections.
• Test switch operation and restore power only after reassembly.