General Electric Microwave Parts

Replacement control panel cover for microwave ovens. Restores the front console's appearance and protects controls from spills. Needed when cracked or broken.

Rubber seal that installs around the inner edge of your microwave door. Replace if cracked, torn, loose, or missing to restore proper door closure.

Replacement side front support bracket for microwaves. Holds and aligns the front panel or door assembly. Install if original is cracked, broken, or missing.

Protective cover that secures the vent motor assembly to the housing. Replace if cracked, broken, or missing to keep the motor aligned and debris-free.

Replaces a worn, cracked, or missing push button on your microwave control panel. Restores easy operation and a clean appearance to your appliance.

The door open button is the push-button component on your appliance that releases the door latch when pressed, allowing the door to swing open. It engages the latch release mechanism with each press so you can access the interior without pulling or prying. Replace this part if the button is stuck, cracked, broken off, or no longer releases the door latch when pressed.

Replacement spring hook that secures the door spring assembly to the microwave frame. Restores proper tension when the original is broken or missing.

This holder assembly secures and positions internal components so they stay stable during operation, restoring proper alignment and preventing rattles or interference. What it does

• Secures internal parts to the chassis or frame to prevent movement and vibration
• Keeps wiring, sensors or small modules in the correct position for reliable operation
• Prevents contact or chafing that can cause noise or intermittent faults
• Replaces cracked, broken or missing mounts that allow components to shift

• Disconnect power to the appliance before beginning any service
• Use basic hand tools; avoid over-tightening fasteners to prevent damage

Replace your cracked, bent, or worn microwave door handle with this stainless steel assembly. Restores clean appearance and secure grip for opening.

This LED board powers and/or controls interior lighting so the appliance interior is illuminated for easier visibility. Replaces a failed or dim LED module to restore consistent, energy-efficient light in the compartment. What it does:

• Provides LED illumination for the appliance interior or compartment.
• Supplies light when the door is opened or when the interior lighting circuit is activated.
• Commonly replaced when lights are dim, flicker, intermittently work, or do not light at all.
• Works with the original mounting and wiring harness to integrate with factory controls.

• Disconnect power to the appliance before servicing to avoid shock.
• Handle the board by its edges and avoid touching LEDs or circuitry.
• Verify proper alignment and secure mounting; reconnect any plugs fully.

Wiring diagram and care guide for your microwave. Helpful reference document for troubleshooting electrical connections and understanding component layout.

Installation template for mounting your over-the-range microwave to upper cabinets. Replace lost or damaged templates to ensure proper alignment during setup.

Replacement use and care manual for your microwave. Includes operating instructions, maintenance guidelines, and safety information for proper use.

Replacement owner's manual and care guide for your microwave. Provides operating instructions, maintenance tips, and appliance specifications.