General Electric Washer Dryer Combo Panel Parts

This control panel front is the exterior cover for the appliance's electronic control area, restoring the unit's finished appearance and protecting buttons and displays from dirt and damage. It's a direct-fit cosmetic and protective replacement. What it does:

• Covers and protects the appliance control keypad and display from spills, dust, and wear
• Provides the correct surface for buttons and touch controls to operate properly
• Restores the appliance's original look when the factory panel is cracked, scratched, or discolored
• Helps prevent moisture and debris from reaching internal electronics

• High-level replacement: remove power and access the control housing before swapping panels
• Typical procedure: detach outer trim or bezel, remove fasteners holding the old panel, transfer any mounted buttons or overlays, then secure the new panel
• Use caution around glass, sharp edges, and wiring; avoid forcing connectors

This front panel assembly replaces a damaged or worn control-panel face to restore the appliance's front appearance and provide a secure mounting surface for controls. It keeps the control area sealed and looking factory-fresh. What it does:

• Replaces the visible front/control panel to cover and protect underlying controls and electronics
• Provides a mounting surface for buttons, knobs, or the touch-control interface
• Helps prevent dirt, grease, and moisture from reaching internal components
• Common repair for cracked, discolored, or broken control-face panels

• One front panel assembly as shown

• Installation requires removing the range/oven console and disconnecting power first — disconnect power at the breaker or unplug the appliance
• Handle panels and clips carefully to avoid damaging trim tabs or painted surfaces
• Use proper fasteners and alignment during reassembly; verify controls and display function before returning the appliance to service
• Label connections and take photos for reference

This front panel is the replacement trim that covers and protects the appliance's control area, restoring a clean appearance and proper access to buttons and the display. Use it when the original panel is cracked, warped, or cosmetically worn. What it does:

• Covers and protects the control board and button area from spills, grease, and wear
• Provides the opening and surface for buttons, touchpads, and the display to operate correctly
• Restores the appliance's original appearance when the front panel is damaged or discolored
• Helps keep internal components sealed from everyday contaminants

• Always disconnect power (unplug or switch off breaker) before starting any repair
• Basic installation typically requires removing the outer cabinet or access screws to reach the control area
• Handle the panel carefully to avoid scratching or cracking; use gentle, even pressure when seating into clips or screw locations

This closure for the control area is the molded cover that protects and finishes the range/oven control panel, restoring a clean appearance and helping keep spills, grease, and heat away from switches and electronics. It's a direct-fit replacement used behind the control knobs and display. What it does:

• Covers and protects the control panel area to prevent spills, food, and debris from entering behind controls
• Restores a flush, finished appearance when the original cover is cracked, warped, or missing
• Helps reduce direct heat and grease exposure to switches and electronic components
• Supports proper seating of control knobs and control-switch hardware

• One closure (control area) cover

• Disconnect power (unplug or shut off breaker) before starting any repair
• Access usually requires removing knobs, trim, and a few screws—handle plastic pieces gently to avoid cracking
• Keep fasteners organized and reuse original screws unless replacements are specified