General Electric Washer Dryer Combo Shaft Or Pin

For complete bearing kit order WE25X10001.

This front suspension rod assembly supports and stabilizes the washer tub from the front of the cabinet. Replacing a worn rod helps reduce vibration, banging, and out-of-balance movement so the washer operates more smoothly.

• Supports and balances the tub from the front corner of the cabinet
• Damps vibration and side-to-side movement during wash and spin
• Helps address symptoms like excessive shaking, banging, or the tub leaning forward
• Reduces walking, rattling, or frequent out-of-balance interruptions

• Disconnect power and water; wear gloves and eye protection
• Support the tub before removing the rod—spring is under tension
• Replace one rod at a time and match the upper/lower end orientation
• Ensure both ends are fully seated in their sockets; re-level the washer after reassembly

This cap stud is a small protective cover that helps secure and shield electrical or mechanical studs on appliances, reducing debris buildup and protecting connections. It provides a simple, low-cost way to maintain safe appliance operation. What it does:

• Covers and protects exposed studs or fasteners from dirt and moisture
• Helps prevent accidental contact with terminals or sharp edges
• Keeps mounting hardware in place for a neater appearance
• Can reduce corrosion risk at exposed connection points

• One cap stud

• Inspect the stud and surrounding area for damage before installing
• Push the cap onto the stud until it seats firmly; no special tools typically required
• Disconnect power to the appliance before working near electrical connections
• Replace if damaged, cracked, or loose to ensure continued protection

A replacement pin alignment used to correctly position and secure moving parts in appliance hinge or latch assemblies. Restores proper alignment to reduce sagging, rubbing, or uneven operation for smoother, quieter performance. What it does:

• Aligns and secures hinge or latch components to maintain correct movement and fit
• Helps stop door sag, binding, or uneven closing when the alignment pin is worn or damaged
• Reduces rubbing and noise caused by misaligned parts
• Restores proper clearance for seals and moving assemblies

• One pin alignment

• Refer to the appliance OEM service manual for model-specific removal and installation steps
• Disconnect power (or unplug) and, if applicable, remove stored contents before working on doors or hinges
• Use basic hand tools; avoid forcing parts or over-tightening fasteners to prevent damage
• If alignment issues persist after replacement, inspect associated hinges, brackets, and fasteners for wear

A small locating pin used to secure and align components during assembly for proper fit and operation. Replaces a worn or missing locating pin to restore correct part positioning and reduce misalignment-related issues. What it does:

• Aligns mating parts during assembly to ensure correct positioning and operation
• Holds components in place to prevent shifting or vibration-related noise
• Helps maintain consistent clearances for moving parts
• Commonly replaced when the original pin is bent, broken, or missing

• One locating pin

• Disconnect power to the appliance before beginning any repair
• Inspect surrounding components for wear or damage when replacing the pin
• Install by aligning parts and pressing the pin into its mating hole until fully seated
• If the pin is press-fit, use appropriate tools (press or mallet with a block) to avoid damage