Need Help?
Call or text
Show parts
Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.
Ice cubes stuck in tray or not releasing? This ice mold and heater assembly warms the tray during harvest to release cubes cleanly into the bin.
Usually ships within 4 - 14 days
Ice maker overflowing or won't stop making ice? This shut-off arm senses ice levels to control production. Simple DIY fix in under an hour.
Replacement ice maker fill cup for bottom-mount refrigerators. Directs water into ice mold during fill cycle. Replace if cracked, broken, or missing.
Fix uneven cleaning and poor wash results with a new spray arm ejector. This part secures the spray arm so it spins properly and distributes water evenly.
Ice cubes jamming or hanging up in the ice maker? This stripper arm guides cubes off ejector fingers into the bin. Requires removing ice maker to install.
Ice maker stopped making ice? The cycling thermostat monitors temperature to control ice production. DIY-friendly repair with video instructions.
Replacement mounting screw for refrigerators and washers. Secures panels, brackets, and components. Replace if stripped, missing, or corroded.
Ice maker won't stop making ice or overflows? This shut-off arm extension restores proper bin sensing. Simple snap-on fix, tricky access in some models.
Replacement mounting screw for refrigerators. Secures panels, trim pieces, and small assemblies. Needed when original screw is missing or damaged.
Plastic front cover for refrigerator ice maker assembly. Snaps onto the ice maker housing. Replace if cracked, broken, or missing to restore appearance.
Fix water dispenser dripping or ice maker not working. This water inlet valve controls water flow to your refrigerator. 10-20 minute DIY repair.
Refrigerator air baffle assembly fixes uneven cooling and ice maker issues caused by poor airflow. Slides into place behind ice maker housing.
Fix controls or components that lose power with this main control wire harness. Routes electrical signals between the control board and key parts.
Secures covers, brackets, and internal panels in your refrigerator. Replace missing, stripped, or corroded screws to restore tight mounting.
Not making ice? This ice maker assembly is the common fix. Most DIYers complete replacement in 25-30 minutes with a socket and screwdriver.
Base mounting screw for vacuum cleaners. Secures the bottom housing and internal components. Replace if screw is stripped, missing, or loose.
Ice maker stopped working or has a burning smell? This thermal fuse clip secures the fuse for safe operation. Simple snap-in installation takes minutes.