Jenn-Air Refrigerator Parts

The video was very helpful, but my KitchenAid model required slightly more steps. Only the two screws in front held the filter housing, same as the video shows, but it has to be removed from the rear. My model did not have the wire brace, only the two front screws held the housing. Shut the water off and pull the electrical plug. Remove the two screws holding the filter housing in the front. Remove the lower panel in the rear at the bottom of the refrigerator. Remove the two screws holding the... Read more

Received exact part and easy to replace, took all of 5 minuets to replace. All you need is a 1/4" nut driver or 1/4" wrench. Super easy ! Read more

The right door on our Jenn Air French Door Refrigerator would pop open & not fully close when the left door was closed first. Called the local distributor/dealer who advised me that the magnetic door gasket probably needed replacement (cost $300.00 + for the repair) What??? Visited you web site where I noted the right door had a "closure & bushing" on the bottom of the door. Could it be this was the problem fix? Took the right door off & examined both pieces. Sure enough the bushing was... Read more

Replaced light switch. That did not work, problem was in led lights. Read more

I replaced it with a new fan motor. Read more

Replace Read more

• Ice maker dispenses too much ice
• Leaking
• Ice maker not making ice

Watched online video and worked along - it was easy and quick - I was amazed! Read more

Bought new optic control boards, both the emitter and the receiver. The repair process was so simple. The KitchenAid repair tech came out to diagnose our issue. He was only going to come back and install a new emitter. They wanted a lot of money to do the repair. They were going to charge us $257 just for the part (emitter board). We bought both boards for $300 from AppliancePartsPros. We decided to replace both boards, because if one went bad the other might not be far behind. Read more

Added a new shaft as the old shaft had worn down...........works perfect now. Thank you Easy fix ....no more than 10 mins. Read more

Replaced old unit with new one Read more

I watched a YouTube tutorial on "fridge's not cooling". A few troubleshooting ideas were discussed, one of which was to replace the "device start" and "run Capacitor". I probably only needed the device start but decided to purchase both through "AppliancePartsPros.com" for a total of $134. It was east to replace and things are starting to cool to their targeted temperatures. Appliance Parts Pros web site saved me from having to purchase a new fridge for about $800. Read more

The noise seemed to be caused by a vibration. The condenser fan motor seemed to have a vibration. I didn't need the fan blade as it came off in good condition. Read more

• Not dispensing water
• Ice maker not making ice

Replaced the water inlet valve. Easy to do. Followed the video, which was the exact way to do it. Don't be confused by the other valve. Read more

Replaced entire ice maker. A couple of important points. (1) The ice maker module does not include all parts. The door flap for example is not included. So save all plastic parts from the old unit including screws. The biggest installation problem was the power cable. There was little room on the side of the ice maker for the cable and connectors to fit. Make sure the connector that mates with the refrigerator cable is seated onto the plastic housing and does not stick out or dangle out.... Read more