Need Help?
Call
Fix a broiler that won't heat or a melted element. This range broil element delivers direct radiant heat at the top of your oven during the broil cycle.
Replaced the element. Read more
Range not broiling or browning food evenly? A failed broil element is the likely cause. This radiant heating coil restores strong, even heat for searing.
Replaced with new ones ordered from your company Read more
Oven won't heat or maintain temperature? A failed bake element causes uneven cooking and long preheat times. This lower heating element restores consistent heat.
Bake element def. replaced with new and now works great. Read more
Broiler not heating or browning food properly? This upper broil element restores intense top heat for even broiling. Takes 15-20 minutes to replace.
Burner won't heat or heats unevenly? This surface heating element restores reliable heat to your electric cooktop. Moderate DIY repair in 30-60 minutes.
Replaced with new burner. Read more
This is a 6-inch radiant surface heating element that sits beneath the glass cooktop on an electric range. It converts electrical energy into heat for cooking and is controlled by the surface element switch or electronic controls. Replace this element if the burner fails to heat, heats unevenly, or does not respond when turned on.
Very good. You sent the part, I put it in and now it’s working. Read more
Burner won't heat or develops hot spots? This radiant surface element restores steady, controllable heat to glass-ceramic cooktops. DIY repair in 1-2 hours.
When the burner failed to come on, I was not sure if it was the burner or the control unit. After doing some research on line, I learned how to test both components. Removing an disassembling the cook top was easy. I quickly identified that the burner failed. Testing it will a multi-meter showed a break in the burner element. I then checked on line for a replacement burner element. The prices ranged greatly, by more than $50. I ordered from ApplicancePartsPros.com. The burner element... Read more
Broiler not heating or element burned out? This upper oven broil element restores intense radiant heat for broiling. Simple plug-in installation.
Turned the power off. Lifted the oven door up and off.to make access easier and to clean an replace gasket.Then unscrewed the element brackets. Cleaned oven. Took oven door apart to replace gasket ,you have to separate the door halves to clean window and get the gasket out. This is where you better take pictures and notes. You need a large work bench and a good #2 Phillips. Taking the elements out you will deal with gouged out screws, rust stripped threads etc. You may need to buy some self... Read more
Replace a burner that won't heat or heats unevenly with this 6-inch surface element. Compatible with electric ranges and cooktops. DIY-friendly install.
We had ordered and installed the drip pans and when we took a look, we knew we needed new elements. Those were perfect; exact replacement. The problem was on the eight inch units, the rim of the drip pan touched the element. It was a simple matter of removing a small bit of the drip pan where the element enters. Aircraft snips and a little polishing with a Dremel tool, and all is well. Wife loves the new elements. Read more
Burner not heating or heating unevenly? This 6-inch surface coil element restores consistent heat to your electric range. Simple plug-in replacement.
I ordered the parts from this company. Read more
Burner won't heat or stuck on high? This surface element restores proper heating control to your electric range stovetop. Common DIY repair.
Replaced it. Read more
This heating element kit replaces a failed heating element to restore normal heating in compatible laundry or cooking appliances. It provides the core heating component needed to get your appliance producing heat again. What it does:
Used wire cutters to replace ceramic terminals; it took less than fifteen minutes. Read more
Broil setting not heating? This upper oven element delivers direct radiant heat for broiling. Easy DIY fix with a screwdriver in under 30 minutes.
Very easy fix. Remove oven door by just opening it slightly and pulling up. (an easy way to clean it too). Then, with a phillips screw driver, remove two screws holding the damaged element in place. Slowly pull the element toward the front a couple inched to expose the wires. Disconnect the wires (no tools needed), remove the old element and replace it with the new. Reverse the past few steps and re-attach the wires and screw. Simple as that. I also chose to replace the Broiler Element as a... Read more
Usually ships within 4 - 14 days
Oven not heating or baking unevenly? A faulty lower bake element is often the cause. This bottom heating element restores consistent temperature. 10-minute DIY fix.
Excellent. I bought the part from AppliancePros and it arrived in 2 day. I followed the instructions on the video and did the repair in 10 minutes. It was easy and great! Read more
Burner won't heat or heats inconsistently? This surface element restores cooking performance. Simple swap-out repair—unplug old, plug in new.
Replaced 6" burner. Read more
Broiler not heating or browning food properly? This upper oven broil element restores high-heat broiling for searing and finishing. Easy DIY fix.
Thanks to you, I was able to purchase replacements and they have been installed and everything works perfectly. Because of you I was able to forgo the price of a brand new range. Thanks for the savings. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.