Kelvinator Parts

Secures cabinet panels to your range frame, maintaining proper alignment and structural stability. Replace if bracket is cracked, bent, or missing.

Replace your range's heat shield guard if cracked, damaged, or missing. This protective component installs to shield nearby parts from heat damage.

Replace your range's heat shield if it's cracked, warped, or missing. This protective barrier installs between heating elements and components.

Push-in plug button that covers openings in the oven bottom panel. Replace if cracked, missing, or broken to keep debris out and maintain a clean finish.

Replacement mounting screw for range power and control boards. Secures electrical board connections. Needed when original screw is missing or damaged.

Insulation shield for electric ranges. Installs to protect internal components from heat. Replace if cracked, damaged, or missing for proper insulation.

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation

Inner door panel liner for chest freezers. Replaces cracked, warped, or broken interior door panels. Essential for maintaining proper door seal.

White outer lid panel for chest freezers. Replaces cracked, dented, or discolored exterior cover. Restores appearance and protects insulation.

Outer door panel for chest freezers. Covers the exterior lid surface. Replace if cracked, dented, discolored, or damaged from daily use or impact.

Freezer not cooling properly or running too cold? This temperature control dial regulates interior temperature. Simple DIY fix in 15 minutes.

This ballast is the electrical control module for a refrigerator fluorescent light assembly, regulating current so the lamp starts and runs properly. Replaces a failed ballast to restore steady lighting and proper lamp operation. What it does:

• Regulates the electrical current to the fluorescent lamp so it starts and stays lit
• Can stop flickering or intermittent lighting caused by a failing ballast
• Prevents lamps from staying dim or not starting at all
• Works as part of the refrigerator's interior lighting system

• One light ballast (1 count)

• Disconnect power to the appliance before servicing to avoid shock
• Access is typically behind the interior light housing or access panel; remove bulbs and cover first
• Handle connectors gently and match wiring location; replace only with the same type of ballast

Secures compressor to mounting bracket in your refrigerator. Replace if clip is broken, loose, or causing vibration noise. Verify fit with your model number.