Kelvinator Gasket & Seal

• Leaking

The dishwasher is 4 years old, so I figured since it was leaking from the bottom, replacing the Tub Gasket PN: AP5690109, Splash Shield Kit PN: AP4338941 , and the bottom Door Seal/Gasket PN: AP5809675 was a good idea; the machine probably has around 1200 cycles in 4 years. There's no telling how much the door had opened and closed!? The bottom Door Seal/Gasket was badly worn, and the entire job took me around 30 minutes which included the detailed cleaning of the mating flanges. Take your... Read more

This door gasket presses into slot around door pull off old and press in new a five minute repair Read more

• Door sweating

With no problem at all Read more

Ordered a new seal, and replaced it with a new one freezer works great now. Read more

I have used this freezer for ~ 10 years with no problems. We have noticed that frost started forming inside the freezer, so after research, the first step was to replace the gasket around the door. I ordered the part and replaced it, which took about 45 minutes. To replace, I would recommend unscrewing the screws around the existing gasket BUT DO NOT REMOVE THE SCREWS as that will take extra work. Just unscrew, and make sure the old gasket comes out of the track easily. To re-install,... Read more

Easy : Pulled off old damaged gasket and pushed on new ones. No tools needed Read more

Replaced the gasket. Five minute repair after door removal. Working great now. Read more

Gasket and liner arrived as planned. Clips were a day later. Used "hog ring" pliers to remove the clips, worked great. Pre-punched holes in the gasket did not match the original but the plastic liner did. Used an ice pick to punch the gasket and inserted the clips. This is a chest freezer, so install the hinge side first. Read more

Replaced the upper spray arm tube with a new one. Also replaced delivery tube grommet and the delivery tube gasket. Now everything works fine and no more leaks. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

Removing was easy. Pull out the ends of the seal, the ends aren't locked in. Then, pull up on each retaining clip. Each clip is held in with spring tension. Reinstallation was easy too. Start on one end, Twist frayed end into cone-like shape and insert into one of the holes for the seal. Push in with a skewer/screwdriver. Insert first clip into the first hole. Go around in a linear fashion, inserting each clip into each hole. After the last clip is pushed in, twist the end of the frayed end... Read more

Loosened the top half screws, pulled the old seal out, put new seal in, snugged top screws, repeated process for the bottom. Went well, no problems. Read more

All by myself Read more

Following the great video on the site, I pulled the motor off and was about to put the o-rings on when I noticed there was rust on the motor shaft. Very close inspection showed the o-rings were still good. Not having time to order a motor, and a local store was having a sale, I replaced the whole unit. Read more

I ordered the replacement and swapped them out. Read more