Kenmore Elite Washer Terminal Block, Receptacle Parts

This moisture sensor connector assembly links the dryer's sensor bars to the control to monitor fabric dryness and adjust cycle time. Replacing a damaged or loose harness restores consistent Auto Dry operation.

• Connects the moisture sensor bars to the main control for Auto Dry feedback
• Transmits the low-voltage signal used to determine when clothes are dry
• Failure may cause Auto Dry to end too soon, run too long, or deliver inconsistent results
• Typical issues include broken wires, loose/corroded terminals, or a heat-damaged plug

• Disconnect power; if gas, shut off gas supply before service
• Access the moisture sensor area at the front/lint housing
• Match routing and clips, seat terminals fully on the sensor tabs, and secure the connector
• Keep wiring clear of sharp edges and moving parts; reassemble and test a Sensor Dry cycle

This motor wire harness links the washer's drive motor to the main control, carrying power and signal connections so the drum can start and regulate spin/tumble. Replacing a damaged harness restores reliable motor operation and helps prevent intermittent faults.

• Carries power and control signals between the main PCB and the drive motor
• Ensures secure, keyed connections at the motor and control board
• Drum won't spin or tumble, or stops mid-cycle
• Intermittent motor operation, humming, or "LE" motor error on some models
• Visible heat damage, broken wires, or loose/burned connectors

• Disconnect power before servicing; allow any capacitors on the control to discharge
• Access the harness by removing the rear or top panel per your model's service information
• Photograph routing and reuse all clips/ties; keep wiring clear of the rotor/drum and sharp edges
• Seat connectors fully (keyed plugs only fit one way); do not force, and secure all strain reliefs

This multi-connector wiring harness routes power and control signals between internal components for reliable appliance operation. Replacing a damaged harness restores secure electrical connections and helps resolve intermittent or lost-function symptoms. What it does:

• Links control board and internal components using multiple connector plugs for correct signal and power distribution.
• Commonly replaced for intermittent operation, loss of specific functions, or visible damaged/burned wiring.
• Ensures connector-to-connector fit to prevent loose connections and arcing that can cause faults.
• Works as a direct replacement harness where the original wiring assembly is damaged or connectors are worn.

• Disconnect power (unplug or turn off circuit breaker) before accessing internal wiring.
• Note connector positions and routing before removal; swap one connector at a time to avoid miswiring.
• Do not force connectors; align pins and push until fully seated. Replace any damaged retaining clips.
• After installation, restore power and test all functions before reassembling panels.