Kitchenaid Dishwasher Guard, Shield, Barrier Parts

The Hinge Brace is an OEM replacement part for Whirlpool dishwashers. It serves as a supportive bracket anchoring the dishwasher door hinge assembly firmly in place.Note: This part may be different from your original. If your original part was a flat plastic vapor barrier, the new design is a wire. It is a factory design change, the old design is no longer available.

Over time, the hinge brace can degrade due to constant use, heavy loads on the door, or accidental impacts. A faulty hinge brace can result in misalignment or difficulty in operating the dishwasher door.

Symptoms of a bad hinge brace include:

• Loose or unstable door that does not close securely
• Gaps appearing around the door seal during wash cycles
• Broken hinge components from added stress and tension on the door
• Difficulty fully opening or closing the dishwasher door

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air and some Kenmore models.

This Barrier protects and separates appliance components, keeping wiring and parts properly aligned for reliable operation. It's a simple, durable replacement that restores the original spacing and support inside the appliance. What it does:

• Provides a stable mounting/separation surface to prevent rubbing or contact between parts
• Helps maintain correct component alignment to reduce vibration and noise
• Prevents wiring or small parts from contacting hot or moving components
• Common symptom: visible cracks, breaks, or shifted parts where components no longer sit securely

• One barrier as shown

• Disconnect power to the appliance before servicing to avoid electrical shock
• Remove any panels or covers that block access; keep track of fasteners
• This part typically installs with screws or snap-fit tabs—do not force components

This replacement shield is a small protective cover that helps guard nearby components from heat, moisture, or debris, reducing wear and preventing damage for reliable appliance operation. What it does:

• Covers and protects adjacent parts from heat, moisture, grease, or debris
• Helps maintain proper airflow or clearance around components where fitted
• Prevents rubbing, chafing, and minor impact damage to wiring or panels
• Can reduce noise caused by loose or exposed parts contacting other surfaces

• One replacement shield

• Disconnect power (unplug or shut off breaker) before inspecting or replacing the shield
• Follow OEM disassembly steps for access; handle mounting tabs carefully to avoid breakage
• Use appropriate fasteners; replace any damaged clips or screws with OEM equivalents