Kitchenaid Wall Oven Parts

Removed 4 screws and replaced panel Read more

After cleaning our stove top, a couple of the grate pads had fallen off the bottom and went down the drain. The pots now rocked while cooking, and not in a good way. I ordered replacement pads installed them and now the only rocking is my cooking. I have used appliancepartspros.com a few times over the years, and ALWAYS get the correct part the first time, and reasonably priced. Read more

Watched video from AppliancePartsPros.com, ordered part. I followed instructions on video and oven door works great now!!! Read more

Since the filter can't be disassembled, I had to buy a new replacement. Just removed it from the box & installed it. Read more

I was just replacing my filter,on my vent. Read more

Searched internet for answers. Decided to replace the door switch. Drier now runs great! Read more

Ordered main control board and top blower. parts arrived as expected and well packaged. replaced main control board. Took two times to get ribbon cable inserted and aligned correctly. display functioned properly, but blower still not turning. replaced upper blower. everything working now. Read more

Only the lower element was burned out, but I opted to replace both. Ordered from AppliancePartsPros and received them very quickly! A few screws, unplug and plug in the new elements, replaced the screws, and DONE! This has to be one of the easiest repairs a homeowner can do. Thanks, AppliancePartsPros for carrying the original equipment parts and providing the fast shipping! Read more

It was a simple process to enter the model number of our glass cook top stove; learn the part number required and order. It arrived in 2-days -- least expensive shipping method. The cooktop was removed with a Phillips-head screwdriver by 4 small sheet metal screws on the right and left side of the oven. The oven's power to the cooktop was easily disconnected via two "clips" and one ground. Would have cost way more with an appliance repair shop and it's an easy do-it-yourself repair. Read more

• Element will not heat

I lucked out my nephew was here to deer hunt and he helped me. I do believe I could have done it on my own but was more confident with his help. I will say the videos did help. Read more

Quick replacement by sliding out the old filters and sliding in the new filters. Read more

I watched the AppliancePartsPros video on youtube and ordered the glass. It arrived in two days and took 20 minutes to install. Read more

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

Replaced control knobs. Read more

I knew for sure that the hinge with the large spring was damaged, but elected to replace both hinges and receivers. Replacing the parts was fairly easy and would have taken me less then an hour. This model has thin metal covers over the hinge assemblies. I found that squeezing in the sides of the covers help to hold them in place on the hinge while reassembling the door. My only difficulty was putting the door back on the oven. It took a little maneuvering but I managed to get it. Now the door... Read more

Ordered the new knob and replaced it. Read more