Lg Washer Parts

Drum bearing bushing for washers. Installs between drum and bearing assembly. Replace if cracked, worn, or missing to restore proper drum support.

Secures internal washer components and maintains proper alignment. Replace when brackets are worn, broken, or causing rattling. Confirm fit with your model number.

Replace your washer's hose connector if cracked, broken, or leaking. This mechanical fitting secures water hoses to your washing machine inlet or drain system.

Replaces worn or torn door boot gasket that seals your washer drum. Replace if you notice water leaks, mold buildup, or visible cracks. Confirm fit.

Directs dryer exhaust from your washer dryer combo to the home vent. Replaces cracked, damaged, or missing outlets that cause leaks or rattles.

Washer not heating or running cold cycles? This thermistor assembly monitors water temperature to ensure proper wash performance. Moderate difficulty repair.

Top plate assembly for washers. Mounts to the back of the machine and covers the top panel area. Replace if cracked, broken, or missing screws.

Fix a washer that won't start, stops mid-cycle, or shows error codes with this main control board. Controls all wash functions and cycles. Pre-programmed.

Rear tub support that holds the inner drum and connects it to the drive assembly. Replace if cracked, corroded, or broken to restore stability.

This is a DC-powered blower fan motor assembly used in the washer to circulate air for drying or ventilation purposes. It helps move air through the drum area to assist with moisture removal. Replace this motor if the washer produces unusual noises during the fan cycle, the blower fails to run, or clothes remain excessively damp after the cycle completes.

Concrete counterweight that bolts to the washer drum to stabilize the tub during spin cycles. Replace if cracked, broken, or missing to restore balance.

Seals the front-load washer door to prevent water leaks. Replace if worn, torn, or brittle to restore watertight seal. Confirm fit with your model.

Replaces a damaged, melted, or scorched power cord assembly on your washer. Restores safe electrical connection when the original cord is burned or worn.

A balance weight that helps stabilize the washer tub during spin cycles to reduce vibration and prevent the appliance from rocking. Replaces a worn or broken cabinet weight to restore smoother, quieter operation. What it does:

• Adds mass to the washer cabinet to counteract tub imbalance during spins
• Reduces excessive vibration, shaking, and loud banging noises when spinning
• Helps prevent the washer from walking or shifting on the floor
• Works as the factory replacement for the original cabinet balance assembly

• Disconnect power and, if applicable, water supply before starting any repair
• Empty the drum and remove the required access panels per your model's service manual
• Securely fasten the weight using the original mounting hardware and torque per OEM guidance

Outer tub assembly for washers. Holds the inner basket and water during wash cycles. Replace if cracked, leaking, or damaged from wear or impact.

Replace your washer's damaged or broken frame panel. This structural cabinet panel restores the outer housing when cracked, dented, or missing.