Maytag Wall Oven Parts

The problem was partly caused because the original legs were at full extension. The replacement legs were longer than the originals and were more secure at the needed length. One difficulty was that the threaded base plate where the legs screwed in had been damaged and had to be reshaped, I was able to reshape the sockets with some effort, to allow the legs to thread in, though one remained slightly angled. (A metal tool of some type which could be threaded in and used to bend the socket area... Read more

A new ignitor was installed, and a new light switch was installed Read more

Removed oven door, took door apart replaced oven hinges. Pulled oven out of recess to access hinge receptacle. Replaced hinge receptacle. Read more

Ordered caps and self installed. Read more

Overall the fix wasn't too hard. The challenge was putting the oven door back together and holding it together while trying to tighten the screws. Enlisted my wife's help to hold the door and at first the handle screws wouldn't tighten. My cordless screwdriver's battery was under-charged. Once I switched batteries I was able to tighten the screws. Seemed like I needed to push too hard (my wife freaked "not so hard you will strip them!") however pushing hard was what was needed. Both screws... Read more

Replaced ignitor. Watch the u-tube videos for removing and replacing the board and ignitor. Read more

• Little to no heat when baking

It took 10 minutes and a screwdriver, remember to turn off power to the oven at the fuse box. By the way, I ordered the part at 1:30pm and received it at 12:30pm the next day using normal shipping, not bad. Read more

One of the heating elements of the stove was burnt. After removal of two screws under the ceramic glass, I replaced the 2500 w heating element (8 inch size). Read more

I ordered a replacement burner from AppliancePartsPros.com and replaced it using a u-tube video to find out how to do it. I took pictures of the wiring before I took it apart and then removed the burner element from the glass tom, but I left all the wires attached. I screwed the new element to the glass top and then one by one I unhooked each wire from the broken element and then hooked them each back onto the corresponding place on the new element. I used the digital pictures I took of the... Read more

Replaced bulbs Read more

The burner lit when I used a lighter so figured it was electrical. There were only 2 electrical components so I first tried replacing the block terminal. This did it, very simple and saved $250 on a whole new unit. Read more

Oven is a slide in. I pulled it out just a Few inches and removed 8 screws and Pulled the face down to expose the unit. The control unit had 4 screws and 4 Plugins. It only took me less than 10 Minutes to replace unit and slide back In place. Read more

I wasn't sure if it would be easier to repair or replace, I went to google and found Appliance Pro and while finding the parts I needed, there were helpful videos on how to install.. So I took the chance and ordered parts, still a little nervous about how this whole process was going to work. The parts came in, I installed them exactly the way I remembered in the videos, my wife is happy again! I'll definitely use this store again for future parts needs! Read more

I purchased the replacement element. The element was a direct replacement. The entire replacement took 20 minutes, 15 minutes of which was to clean the range before putting it back. Read more