Microwave Gasket & Seal

This OEM Replacement Part is an Adhesive designed for use in high-temperature areas of your Whirlpool appliances. Approximately 7.5 inches long, this white adhesive is suitable for securing parts such as grate feet, gaskets, and felt seals. It is especially useful, particularly in hot zones like a cooktop. The heat-resistant properties of this adhesive ensure that the bond integrity remains uncompromised even under high-temperature conditions.

Contained in a 3oz bottle, this adhesive forms a resilient bond between various components. It is commonly used in conjunction with gaskets, felt seals, and rubber feet. The RTV high temp silicone adhesive/sealant guarantees the safety and longevity of your appliance by ensuring a secure fit of parts exposed to high heat.

This packing is a replacement door gasket that seals the appliance cabinet to keep cold in and warm air out, helping maintain proper cooling and reduce frost buildup. It restores a tight seal around the door for consistent performance. What it does:

• Replaces a worn or torn door seal to stop warm air leaks and reduce frost and moisture inside the compartment
• Helps the appliance maintain set temperatures and can improve cooling consistency
• Can reduce unnecessary compressor run time caused by poor sealing
• Addresses symptoms like visible gaps, cold loss at the door, or excessive frost buildup

• Disconnect power to the appliance or unplug before starting work
• Clean the door frame and contact surfaces before installing the new gasket to ensure a good seal
• Align and seat the gasket evenly around the door; some gaskets require gentle stretching or warming for proper fit
• Inspect door hinges and closing action; adjust if the door does not close evenly after gasket replacement

This flexible rubber door boot gasket seals the washer tub to the front door, helping contain water during washing cycles and reducing leaks. It restores a tight, water-resistant seal for front-load washers that show leaking or visible gasket wear. What it does

• Forms a watertight seal between the washer door and tub to prevent water from escaping during cycles
• Helps keep dirt and lint out of the door seal area to reduce odors and buildup
• Addresses common symptoms like visible cracks, splits, flattening, or water leaks at the front door
• Restores proper door alignment contact for reliable washing performance

• One replacement door boot gasket

• Disconnect power and water supply before beginning any repair
• Drain the washer and open the door; remove the outer clamp and old gasket carefully to avoid damaging the door or tub
• Clean the mating surfaces before installing the new gasket and align the bead evenly around the tub and door opening
• Reinstall clamps or retaining bands securely; test with a short cycle and check for leaks before normal use