Bosch Dishwasher SHV57C03UC22 Parts
Bestselling
Price High to Low
Price Low to High
By: Bosch
Part Number: 00166625
The Sealing is an OEM replacement part for Bosch brand dishwashers. Located on the perimeter of the small rinse aid compartment door, this resilient rubber piece forms an essential water-tight seal when the dispenser is closed.
Symptoms of a potentially problematic rinse aid door sealing include:
Leakage or spills within the rinse aid reservoir
Mineral deposits or residue build up inside the compartment
Cracks, tears, or deformation of the sealing material
Causes of a faulty rinse aid door sealing can be repetitive opening/closing stress breaking down pliability long-term. Exposure to chemical vapors from the rinse aid may also degrade sealing properties.
This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Dishwasher rinse agent reservoir had leaky door. Joan W. • Woodbridge , VA • July 25, 2020
Ordered new door and seal. They arrived in just a few days. Watched the video on this site.
Snapped out the old door and snapped in the new door in about 15 seconds
Read more
More
$12.95
Compare At:
$15.41
You Save:
$2.46
By: Bosch
Part Number: 00088403
2 clamps included.
Do-It-Yourself Stories from Customers like You
Needed a new dishwasher drain hose and the hose connecting piece that attaches to the garbage disposal John H. • Kennett Square , PA • September 26, 2016
Fixed it myself. Took only 15-20 minutes to remove the old hose and connect the new one. The parts were exactly what I needed to make the repair. The repair video on the website was very helpful.
Read more
More
$19.21
Compare At:
$22.86
You Save:
$3.65
By: Bosch
Part Number: 00165263
Plastic cover that protects the drain pump mechanism from debris. Replace if cracked, broken, or tabs are bent preventing proper seal during drain cycles.
Do-It-Yourself Stories from Customers like You
No spray during wash cycle pump impeller was broken. Robert K. • Cazenovia , NY • February 22, 2019
Watched AppliancePartsPros video, disassembled the dishwasher and replace impeller and seals.
Read more
More
$10.95
Compare At:
$13.03
You Save:
$2.08
By: Bosch
Part Number: 00165281
Fix dishwasher not heating or running for hours. This NTC temperature sensor monitors water temp and prevents overheating. Moderate DIY repair with video.
Do-It-Yourself Stories from Customers like You
Bosch dishwasher not heating water or drying dishes machine cycled for 3+ hours Tom B. • Arcade , NY • July 05, 2015
Ordered new heater/thermostat piece.
Read more
More
$89.71
Compare At:
$98.68
You Save:
$8.97
By: Bosch
Part Number: 00350321
Replacement water feed tube that delivers water to the upper spray arm in your dishwasher. Replace if cracked, split at seams, or leaking due to wear.
Do-It-Yourself Stories from Customers like You
Dishes were not getting clean Dorman P. • Ponte Vedra Beach , FL • October 18, 2014
After we saw that progressively our dishes were not getting clean we investigated the condition of the spray arms and this upper feed tube assembly. We found a huge crack on the side of this piece and new not enough water was getting to the arms. We also noticed a build up of soap and lime. So we ran a cycle of vinegar and sprayed the filters and arms with lime-off-sprayed them out with a air hose "completely". Many of the small pieces of lime will clog the holes in the spray arms. Attached the...
Read more
More
$81.39
Compare At:
$96.04
You Save:
$14.65
By: Bosch
Part Number: 00263833
Fix a dishwasher that won't fill, overfills, or leaks from the base. Water inlet valve controls flow into the tub. Moderate DIY repair, 30-45 minutes.
Do-It-Yourself Stories from Customers like You
Horrible smell when running a cycle Aaron H. • Los Angeles , CA • January 13, 2017
Bacteria buildup in the venting assembly and drain hose. Replaced them and it's back to normal
Read more
More
$150.95
Compare At:
$179.63
You Save:
$28.68
By: Bosch
Part Number: 00298550
This upper trim strip finishes the top edge of the appliance's front opening, restoring a clean look and helping protect nearby components. Replace a cracked, missing, or loose strip to keep panels aligned and secure.
Provides a finished edge along the upper portion of the door/face area Helps protect adjacent components from dust and minor splashes Maintains proper panel gaps and alignment Typical symptoms: visible cracks, warping, looseness, rattling, or exposed/sharp edges What's included: 1 upper trim strip Install notes:
Disconnect power before servicing; also shut off water Remove the existing strip by releasing screws/clips; retain hardware for reuse Align the new strip and secure evenly—do not overtighten fasteners Check door/panel operation afterward to confirm proper fit and clearance
Do-It-Yourself Stories from Customers like You
Old pieces worn out Michal W. • Sterling , VA • July 18, 2015
My micro filter was in pieces when I pulled it out.
Read more
More
$25.95
Compare At:
$30.62
You Save:
$4.67
By: Bosch
Part Number: 00499500
This pressure chamber is part of the water level sensing system in the dishwasher. It connects to the tub and the water level sensor, using air pressure changes to detect how much water has filled the machine so it knows when to stop filling. Replace this component if the dishwasher overfills, underfills, or displays water level error codes during a wash cycle.
Do-It-Yourself Stories from Customers like You
Internal water leak on a bosch shu5316 uc/06 dishwasher David B. • Aspinwall , PA • March 13, 2015
Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a...
Read more
More
$60.55
Compare At:
$72.05
You Save:
$11.50
By: Bosch
Part Number: 00165301
The Float is an OEM part for Bosch dishwashers. This float senses water levels inside the dishwasher, signaling the inlet valve to refill when needed.
Causes of a float malfunctioning can be mineral deposits accumulating and weighing it down over time, or cracks in the plastic housing allowing water in.
Symptoms of a bad float include:
The dishwasher not filling or filling slowly
Error codes related to fill issues
Improper water levels impacting wash results
This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.
Do-It-Yourself Stories from Customers like You
Flood switch was stuck in on position drain pump would not turn off. Rick V. • Burlington , IA • April 05, 2017
Replaced the defective float switch.
Read more
More
$7.69
Compare At:
$9.07
You Save:
$1.38
By: Bosch
Part Number: 00165331
O-ring seal prevents leaks between dishwasher components. Replace when you notice water drips or moisture buildup. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
We had water that wouldn't completely drain from the dishwaser Melanie D. • Syracuse , UT • June 05, 2015
WE replaced the drain pump and it still wouldn't drain sometimes. Finally we realized that the drain hose wasn't the correct bosch hose and the rubber was starting to bend and kink where it went through the hole to under the sink.So we bought the drain hose and replaced.
Read more
More
$13.95
Compare At:
$16.60
You Save:
$2.65
By: Bosch
Part Number: 00166635
Wax motor for detergent/rinse-aid dispenser.
Do-It-Yourself Stories from Customers like You
Soap dispenser door wouldn't open David H. • San Francisco , CA • May 15, 2015
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks.
Read more
More
$29.68
Compare At:
$35.02
You Save:
$5.34
By: Bosch
Part Number: 00267739
Rear pump housing for the washer drain/pump assembly. Replaces the worn rear housing that supports the impeller and bearing, helping restore proper draining and reduce leaks or unusual pump noises when the housing fails. What it does:
Houses and supports the pump impeller and bearing, forming the rear half of the drain pump assembly. Restores a sealed mounting surface to help prevent water leaks from the pump area. Helps re-establish correct water flow and draining when a cracked or worn housing impairs the pump. Addresses symptoms such as poor or no draining, water at the base of the appliance, or loud/grinding pump noises. What's included: One rear pump housing. Install notes:
Disconnect power and shut off water supply before starting; drain any standing water to avoid spills. Remove the washer access panels and pump assembly; transfer the impeller, seals, and any hardware as required. Inspect and replace pump gaskets/seals and the impeller if worn; tighten mounting fasteners to OEM torque where specified.
Do-It-Yourself Stories from Customers like You
Very little water pressure coming from spray arms only sprayed about 6" Kevin H. • San Antonio , TX • August 18, 2019
Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger.
When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed...
Read more
More
$35.49
Compare At:
$41.88
You Save:
$6.39
By: Bosch
Part Number: 00166628
Detergent not dispensing during wash cycle? This actuator arm with spring releases the detergent cup at the right time. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Control panel was cracked. Janet C. • Loganville , GA • April 01, 2023
Ordered a replacement control panel and installed it according to the AppliancePartsPros.com YouTube video.
Read more
More
$10.63
Compare At:
$12.54
You Save:
$1.91
By: Bosch
Part Number: 00187527
This dishwasher door spring counterbalances the door's weight for smooth, controlled opening and closing. Replacing a worn or broken spring restores proper door tension and helps prevent the door from dropping quickly or feeling heavy.
Provides tension to counterbalance the dishwasher door during opening and closing Helps prevent the door from slamming open or feeling overly heavy A weakened or broken spring can cause uneven door movement, squeaks, or the door not staying in a partial-open position Restores smooth, even door operation when replaced Install notes:
Disconnect power and turn off water supply before servicing Remove the toe-kick and carefully slide the dishwasher out to access the side/frame area where the spring attaches Note the original spring attachment points and orientation; install the new spring in the same locations Springs are under tension—use caution and hand protection; many replace both springs together to maintain balanced tension
Do-It-Yourself Stories from Customers like You
Door cables broke on our dishwasher and everyone said parts not available but appliance parts had them at a fair price and shipped them that day Jeff W. • Stillman Valley , IL • March 01, 2026
Ordered the parts and had a local appliance store do the work, complete Job for $
Read more
More
$30.95
Compare At:
$36.83
You Save:
$5.88
By: Bosch
Part Number: 00424819
Dishwasher indicator light not working or staying on? This light signals cycle status and alerts. Common fix for control panel display issues.
More
$52.23
Compare At:
$62.68
You Save:
$10.45
By: Bosch
Part Number: 00165258
Black adapter connects dishwasher drain hose to another hose or fitting for secure wastewater routing. Replace when cracked, loose, or missing for leak-free.
Do-It-Yourself Stories from Customers like You
Dishwasher drain hose developed a small leak James W. • Salinas , CA • November 17, 2019
Ordered a new drain hose and coupling to attach to the garbage disposal. Parts arrived in less than a day, awesome. Watched video on your site showing how to do it. Video is good but I needed to remove from base plate and side panel attached with star screws to get to the point the video showed.
Read more
More
$6.42
Compare At:
$7.64
You Save:
$1.22