Kenmore Refrigerator 253.63812200 (25363812200, 253 63812200) Parts

Replace them. Out of two shelf guards 1 was broken Read more

Put racks to together and put into fridge Read more

I removed the meat drawer and shelving unit. I unscrewed the Philips head screws on either side of the shelf brackets. I cleaned the old surfaces and fitted the new plastic hangers in place. I screwed the new hangers in place with the screws I had from the old ones. It was very easy, except the holes in the plastic hanger are not quiet big enough for the screws. I had to push very hard with the screwdriver, and started to strip the head of the screw as well at the screwdriver itself. I did... Read more

This was a 2000 model so rather than just replace the defrost timer which was visibly burnt on the terminals, we just did everything. The cold control, defrost timer, thermostat, defrost heater and the compressor capacitor were all replaced. I had the same issue on my older unit and tore it apart replacing one item at a time over a three month period so on an older one i suggest do it all while it is apart. Read more

I ordered a replacement handle and screws. The process was very easy with the help of one of your "pros" who found all the parts needed and took my order. I didn't realize I was getting both a refrigerator door handle and a freezer door handle in one set, but now we have the freezer handle if we need it. Removing the old handle and installing the replacement was very easy. It looks great, in fact the replacement is metal, whereas the original was plastic, so it looks better than it ever did! Read more

The bar retainers just snapped in and the door handle can be replaced with three screws. Took about 5 minutes total. Read more

Put racks to together and put into fridge Read more

Put racks to together and put into fridge Read more

Replace them. Out of two shelf guards 1 was broken Read more

• Door won't open or close

I put a piece of two-by-four, (2"x4") about 10-inches long on edge under the door to support the door. I removed the 3-bolts attaching the door hinge at the bottom corner. I then slid the washer onto the post and placed the bracket back in place with the 3-bolts. That did the trick. I used a 3/8-inch socket with extension and a ratchet. Read more

• Door won't open or close

My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more

No problem, 1 min to fix Read more

Ordered parts from appliance part pros Read more

No problem, 1 min to fix Read more

My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more

Took a photo of label, went to this site, which I have used for several years for several rental units, part arrived in a day. Simple install, easiest place to find parts for appliances. Read more