Kenmore Refrigerator 253.77172508 (25377172508, 253 77172508) Parts

FIrst, I removed the cardboard cover on the back, exposing the compressor compartment. I noticed the fan was not moving. I touched the blade and it immediately started spinning, but not very fast. The compressor was getting hot, and I think prob. overheating. The fan stopped after a few hours and then "froze" solid the next day. I got the parts and I followed the process in the video to replace the fan. VIdeo was right on the money. but there were some difficulties. The retention clip on the... Read more

• Door won't open or close

I put a piece of two-by-four, (2"x4") about 10-inches long on edge under the door to support the door. I removed the 3-bolts attaching the door hinge at the bottom corner. I then slid the washer onto the post and placed the bracket back in place with the 3-bolts. That did the trick. I used a 3/8-inch socket with extension and a ratchet. Read more

• Noisy

No local refrigeration house had one. APP did! I got it in 2 days. Everything is A OK. Read more

• Door won't open or close

My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more

Simply removed broken bin, and snapped in new ones. No tools needed. Appliance Parts Pros rep was very knowledgeable on its inventory for the parts I needed. Highly recommend this company. Fastest delivery experience ever. Excellent customer service. Read more

I snapped the shelves in place. It was very easy! Read more

No problem, 1 min to fix Read more

Installed missing bins from a refrigerator Read more

My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more

• Leaking

Changed the Frigidaire Icemaker Fill Tube Part # 241796405 (AP5671747) about a week ago and so far the Frigidaire Refrigerator seems to work fine. Did not use other ordered parts. Recently ice formed around internal evaporator fan and it started making loud noise when then fan and compressor, etc were running. A long winded history noted below if interested: I have been fighting with this Frigidaire Refrigerator for about 3 to 4 years, started out with the evaporator fan making noise when ice... Read more

Looked up possible causes on line and found video about trouble shooting. It said to check starter cap and run relay on side of compressor. Removed both and found both were bad .ordered replacements on line from appliancePartspros.com. Installed new parts and is working properly. This repair job was on a 2012 Frigidaire refrig. You would think a refrig. Would last longer than 4 years. The original parts and the replacement parts were light weight and cheaply made. I'll probably be doing this... Read more

• Light not working

Ordered switch....turned out it was the socket that was bad...ordered socket.....quick install....light works Read more

Removed two screws to remove the broken handle, replaced it with the new handle and tightened the two screws to hold it in place. Read more

Removed old seal and installed new seal. I laid down the new seal in the sun for about 20 minutes and it went in the grove extremely easy. Read more

I wasn’t sure where I could get parts for the fridge, Google brought me here. Super easy to look up model #’s and locate parts by type/location with the appliance map. I needed to change the racks and the doorstop. The racks were super simple. I would have succeeded with the doorstop too, but the holes at the bottom are stripped and the doorstop wasn’t secured correctly in the first place. So that’s frustrating, but appliance parts pros were easy to use, parts came quickly and The video from... Read more

Everything was easy to replace. Did it all by hand except the access cover that needed a socket wrench. The door didn't close that well at first. I had to wait a couple of days for the rubber pieces to fit into the door frame. Read more