Kenmore Dishwasher 665.13864K600 (66513864K600, 665 13864K600) Parts

4-24 x 3/8 screw secures trim panels, brackets, and internal components in your dishwasher. Replace if missing, stripped, or corroded during repairs.

Replacement door balance link mount for dishwashers. Secures the door balance mechanism to the cabinet. Needed when original mount is cracked or broken.

This kit includes hose clamps and fasteners used during dishwasher installation to secure the drain hose and water supply connections. It ensures tight, leak-free connections between the dishwasher and household plumbing. Replace this kit if you notice water leaking at hose connections or if clamps are corroded, broken, or missing during a new installation or reinstallation.

Secures interior panels and trim to prevent vibration and movement. Replace when clips break or lose grip. Verify fit with your model number.

This bracket supports the rack adjustment mechanism in dishwashers, allowing height changes for different dish sizes. Replace if racks won't adjust properly, are unstable, or the adjustment mechanism is broken.

This is a rack adjuster mechanism that allows you to raise or lower the upper dish rack in your dishwasher. It attaches to the side rail and enables height adjustment to accommodate taller items on the lower rack. Replace it if the upper rack tilts, sags to one side, or the adjuster no longer locks into position.

White toe panel that covers the bottom front of your dishwasher. Replace if cracked, discolored, or missing to restore a finished appearance.

Access panel covers the base of your dishwasher, concealing wiring and mechanisms. Replace if cracked, broken, or missing after installation.

This manifold spinner assembly routes and spins rinse water and dispenser output so detergent and fabric softener reach the load evenly. It restores proper dispenser flow and helps maintain consistent rinse performance. What it does:

• Spins to distribute dispenser and rinse water across the tub for even coverage
• Restores proper flow from the machine's dispenser when the spinner is worn or broken
• Can reduce uneven rinsing or leftover detergent caused by a damaged spinner
• Works as the rotating outlet component of the dispenser/manifold system

• Disconnect power and water supply before beginning any service.
• Remove access panels and dispenser/manifold housing; keep fasteners organized.
• Inspect surrounding seals and hoses; replace if cracked or brittle.

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

This is a small plastic or rubber fitting that secures the power cord where it enters the dishwasher's junction box or base. It prevents the electrical wiring from being pulled, kinked, or damaged by absorbing tension on the cord. Replace this part if it is cracked or missing, which can leave wiring exposed and vulnerable to damage during installation or use.

Broken detergent door latch or dispenser won't close? This dishwasher dispenser assembly fixes soap release issues. DIY repair takes about 1 hour.

Fix water leaking from under your dishwasher with this pump volute. Directs water flow and prevents leaks with integrated seal. 20-minute repair.

This replacement screw fastens appliance components such as panels, brackets, or trim. Use it to replace a missing, stripped, or rusty fastener and restore a secure, rattle-free fit in your appliance assemblies.

• Secures panels, brackets, or hardware to maintain proper alignment
• Helps eliminate vibration, rattling, or loose-feeling parts
• Replaces fasteners that are missing, corroded, or cross-threaded
• Typical signs you need it: loose handle or panel, gaps, or hardware that won't stay tight

• Disconnect power (and shut off gas, if applicable) before servicing
• Match thread type and length to the original fastener for proper fit
• Start threads by hand to avoid cross-threading; do not overtighten
• Reuse any original washers or clips if present