Kenmore Dishwasher 665.13873K602 (66513873K602, 665 13873K602) Parts

Secures interior panels and trim to prevent vibration and movement. Replace when clips break or lose grip. Verify fit with your model number.

This bracket supports the rack adjustment mechanism in dishwashers, allowing height changes for different dish sizes. Replace if racks won't adjust properly, are unstable, or the adjustment mechanism is broken.

Small retaining clip that secures trim, panels, or components in your dishwasher to prevent rattling or detachment. Replaces broken or missing clips.

This manifold spinner assembly routes and spins rinse water and dispenser output so detergent and fabric softener reach the load evenly. It restores proper dispenser flow and helps maintain consistent rinse performance. What it does:

• Spins to distribute dispenser and rinse water across the tub for even coverage
• Restores proper flow from the machine's dispenser when the spinner is worn or broken
• Can reduce uneven rinsing or leftover detergent caused by a damaged spinner
• Works as the rotating outlet component of the dispenser/manifold system

• Disconnect power and water supply before beginning any service.
• Remove access panels and dispenser/manifold housing; keep fasteners organized.
• Inspect surrounding seals and hoses; replace if cracked or brittle.

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

Replacement mounting nut for dishwashers. Secures internal components and panels. Order a new nut if yours is stripped, missing, or damaged.

This bracket mounts inside the dishwasher tub and supports the middle spray arm manifold tube, holding it securely in position. It ensures the spray arm tube stays aligned so water is properly distributed during the wash cycle. Replace this bracket if the middle spray arm wobbles, falls out of place, or if dishes on the upper rack are not getting clean due to poor water coverage.

Fix a dishwasher motor that hums or won't start. This run capacitor provides the phase shift needed for smooth motor operation. DIY repair in 30-45 min.

Insulation pad that fits behind dishwasher panels to restore thermal protection and reduce noise. Replace if damaged, missing, or rattling occurs.

Dishwasher door seal prevents water leaks between the console and door. Replace if you notice leaking during cycles or visible wear. Confirm fit with model.

Dishwasher won't start or stops mid-cycle? This door switch detects when the door is closed to allow operation. Common DIY fix for no-start issues.

Replaces broken, melted, or missing lower rack insert. Secures and separates dishes in the lower rack. Snaps into place without tools needed.

Secures the dishwasher vent assembly and directs steam. Replace if cracked, loose, or causing leaks around the door vent. Confirm fit by model number.

Fix a dishwasher that won't fill properly or overfills with this overflow switch lever. Restores water level detection. DIY-friendly repair.