Samsung Refrigerator RF267ADWPXAA Parts

• Ice maker dispenses too much ice

This appears to be a weak spot on these refrigerators; the left-door ice maker will stop making (or at least consistently making) ice. Instead, an ice dam is created, which builds up in the ice maker corridor, making even getting the slide-in bucket nearly impossible to remove. The ice also freezes up the ice making tray, which therefore cannot drop the ice cubes. Generally, two things may go wrong which lead to this issue. The first is the ice-making assembly; its electrical components... Read more

First, I removed the old gaskets, which was a very easy task since they are held in the doors by rubber beads in recessed slots. I installed the new right door gasket in less than 10 minutes by gradually pushing the retainer bead into the door recessed slot with finger pressure until it was seated properly. The left door bead was somewhat more difficult to install into the bead slot, because the recessed bead slot is covered by a hinged flap on its left edge that doesn't permit easy access.... Read more

After looking online and discovering that others who had used a knockoff brand filter to "save money" had the same problem, I concluded the only solution was to replace the filter housing. Found the one I needed on AppliancePartsPros.com. Most important to me was the video explaining how to replace the filter housing - it made the task a snap to complete. The price was also competitive with other sources. Shipping was half that charged by Samsung. Not only was it cheaper, but it was also super... Read more

• Fridge too warm
• Doesn't shut off
• Noisy

The blower motor that circulates air through the refrigerator was broken. I had to remove all the shelving and drawers from the refrigerator. Then I had to remove the plastic light cover from the center of the fridge. Then I removed all visible screws to uncover the evaporator/radiator. I then unplugged the light bulb and motor wires. Luckily all wiring is keyed so that it can be plugged in again without error. I removed the motor by opening the motor housing. The housing has 1 screw and... Read more

I took all the items out of the refrigerator. Removed the screws that hold the cover over the evaporator motor. Than for three hours used a hair drier to remove ice. The panel was frozen on if you pull on it it will break. Soaked up all the water removed the panel and took the fan blade off. That was difficult because it looks like a regular screw head however, you need to push in that which will cause it to release the blades and than push it onto the new motor. Than replace the panel put the... Read more

Removed broken piece, installed new piece. Read more

Called sears for repair. Diagnosed that the ice maker was not allowing water to enter in when the cycle was complete. I saw that it was a simple fix, and saved about $300 by doing it myself. Order the ice maker from appliancePartsPros.com and simply replaced the ice maker myself - easy peasy. Side note, the parts ordered from the site was delivered within 24 hours when I didn't select expedited shipping. I was amazed at the timely delivery. Read more

Pulled out Drawers - Unscrewed old rail - Screwed the new rail in . Very Simple - Only concern was the right fitting part. Part Arrived only a couple days after I placed the order. Read more

Ordered replacement clips. The replacements don't come with screws or the caps to cover the screws, so save all the hardware aside from the plastic hinges. You need to order the upper and lower halves of the hinges. The repair was very quick and easy, took about 5 minutes to attach the hinges to the shelf, and screw the shelf back into the side of the ice maker. Very happy to have the shelf back. Read more

Removed the vegetable drawers, removed the shelf above them. Removed two screws (philips #2) holding the left drawer rail in place. Levers the front of the rail away from the side of the refrigerator and pulled, sliding the tab at the rear of the rail out from the fridge wall. Placing the new rail had some challenges due to extra plastic at the far end of the rail. I needed to carefully cut/trim (with large diagonal cutters) the plastic tab to match the old rail otherwise the extra plastic... Read more

• Light not working
• Not dispensing water
• Ice maker not making ice

We took out the filter and then popped this cap right in. Could not have been more simple. Read more

Part replacement Read more

Ordered replacement clips. The replacements don't come with screws or the caps to cover the screws, so save all the hardware aside from the plastic hinges. You need to order the upper and lower halves of the hinges. The repair was very quick and easy, took about 5 minutes to attach the hinges to the shelf, and screw the shelf back into the side of the ice maker. Very happy to have the shelf back. Read more

Called talked to a very skill lady in parts that got me the right parts Read more