Customer Questions and Answers for Washer Main Control Board by Frigidaire

Hello John, you can normally grasp it with your fingertips and pull it out but you can pry up on it with a small screwdriver a bit to get hold of it if needed.

Hello John. No, they will not fly out, but they will be loose. Just take your time and you shouldn't have any issues installing the new board into the unit.

Hello Cari, This sounds like a connection issue. I would open the unit and dis-connect and reconnect each connector several times to ensure a good connection. The other explanation would be a shorted component that is causing board failure.

Hello Cari, If the cancel button reset does not remove the E90 error code, try a full power reset. To accomplish this type of reset, unplug the washing machine and wait 15 minutes. Then plug the washing machine back in and make a new wash selection. If the error code does not return, normal function may resume. Unfortunately, if the cancel button and/or full power reset attempts do not eliminate the E90 error code, it is very possible that the electronic control board 137007010 will need to be replaced.

Larry, When the washer is in a fill cycle and the control does not see a frequency change from the pressure sensor, the cycle will be paused, the drain pump will run for 3 minutes and the display will continuously scroll H2O supply. This can occur when the water supply is turned off, the inlet hoses or water valve screens are clogged, a water valve or pressure sensor issue, a leaking pressure sensor hose or a poor electrical connection or wiring. If the H2O supply is still scrolling on the screen after the repair has been made, follow these three steps. 1. Allow the drain pump to run until it shuts off on its own. 2. wait 10 seconds and then turn the cycle knob to change its position. The h20 supply should be cleared from the display.

Stephanie, With the E23 error code stating that there is a issue with the drain pump relay on the control board, this would require a new main control board part number 137006000.

Hello Larry. You will need to check and see if the valve 134371220 is bad and will need to be replaced on the unit.

Hello Gunvantsuthar. If you ordered the board from us, here is our return policy. http://www.appliancepartspros.com/customerservice/returns.aspx

Stephen, The E5E error code is a communication problem. The following is the manufacturers recommendation for communication problem. Communication problem. Check the wiring between the Main Control Board and the Speed Control Board. Wiring bad, correct wiring problem. Wiring good, replace the Main Control Board. If the problem is not corrected, replace the Speed Control Board.

Hello Beth. The next step would be replacing the water valve 134371210 on the unit.