Customer Questions and Answers for Sensor Assembly by Lg

Hello Tony. No. You need to test for power to the control board. If there is power there, and it does not run, you will need to replace the control board on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hello Kristen. Based on the information you provided, you will need to order and replace the bracket assembly 4811ER3001A on the unit.

Hello Carlos. The drying poorly issue and the vent assembly is where the air comes out of the dryer assembly and it removes the warm moist air in the unit.

Hello Carlos. Yes, the sensor 6501FA2462E can cause this issue. Most of the time the issue is the vent assembly not properly working and it causes the issue you are having.

Hello Travis.

The sensor you were lookin at is the ball sensor used to sense an out-of-balance load. The hall effect sensor is part number 6501KW2002B.

Hi Jeff. The U.E. code can be from anything that will allow the unit to be unbalanced. • The load is too small.• The appliance is tilted.• Laundry is gathered to one side.• Non distributable things are put into the drum. Make sure that the unit is level front to back and side to side. Make sure the level legs are locked with the nut tightened back towards the base. Make sure the legs can grip a clean floor. If the legs are damaged they are part # AFC72909501. Remove the top. look to see if the top center tub springs are located in the top frame mounts and lightly greased. They need to be replaced in pairs. They are part # 4970FR2084N. Open the back and see if the tub shocks are loose or if there is any grease or oil leaking out. They are part # 383EER3001E. If the holding pins are broken replace them with part # 4774FR3118B. Open the door and with no clothes, spin the tub and see if there is more than 3/8" run-out (up and down movement) of the tub. Make sure that it is not wearing into the front of the boot assy. The tub is part # 3045ER1006E. Check the back pulley bolt. Is it tight ? It is part # 4040FR4051C. Are all the shipping bolts in the back removed ? Thank You.

Hello Mike. Check and make sure none of the rotor magnets are cracked or broke. If they are good, then you will need to replace the stator assembly 4417FA1994G. It comes with the RPS sensor. Hope this helps.

Hello Mike. The sensor assembly 6501FA2462E is used for sensing out of balance loads. The switch assembly 6600FA1704X is used for the water level. Hope this helps.

ball sensor assy. cannot be ohmed for continuity. It emits the a frequency of light to send to the main control board if the ball is move out of the "resting" hole during the beginning of a bad rotation cycle. Then the main control board will stop the rotation and start a slow rotate and counter rotation to re balance the load before it ramps up again. The sensor mounts on the original mount with a screw that was with the original one. This sensor is part # 6501FA2462E. Thank You.

Hi T.J. U.E. = IMBALANCE
ERROR. The load is too small.
• The appliance is tilted. Make sure the unit is leveled from front to back and side to side with the level legs "stud nuts" locked tight up against the base.
• Laundry is gathered to one side.
• Non distributable things are put into the drum. Redistribute the clothes evenly. Replace the part # 6501FA2462E. Thank You.