Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Water Tank Heater by Samsung

Best Seller
Manufacturer Part
4.89 (64)
By: Samsung
Part Number: OEM12408144
Manufacturer Part Number: DA47-00094C

Questions & Answers

For Samsung Water Tank Heater (Part Number: OEM12408144)

1 Answer

Hello Ram. It sounds like you may have a defrost problem with the unit. Check and see if there is any frost build up on the evaporator coils in the freezer. If so, you will need to test the defrost heater and the defrost thermostat. They should read closed for continuity when cold. You can test this with a multi-meter TJMA-DMT3. I will include a link at the end to assist you how to use the multi-meter if needed. If both parts are good, you will need to replace the defrost timer. Once the problem is repaired, you will need to thaw out the ice on the coils before the unit will operate properly. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Read More...

1 Answer

Hello Bob. DA47-00094C is not a defrost heater. It is the water tank heater. It is testing good. The readings are based on temperature being tested. The only way to replace the heater is replace the evaporator coils DA96-00020Q.

Read More...

1 Answer

Hello Donald! Unfortunately, the Whirlpool does not offer a refrigerator garage heater kit. Sorry about that!

Read More...

1 Answer

Hello Alba. Make sure the condenser coils are clean and the condenser fan motor is good on the unit.

Read More...
Rob

Fridge is a Samsung RS2555SL Side by Side. Fridge evaporator coils freeze up so I have narrowed to a defrost cycle issue. I replaced the defrost sensor and that did not fix the problem. Based on research, it looks like it can only be one of 2 remaining failures. The heater (MFG Part Number: DA47-00094C) or the main board. When I power off/on the fridge, the front display shows a 3 before returning to ready state. I know this signifies a defrost problem but does it indicate a particular part failure? The main board is the more expensive part so I tested the heater with a multimeter and it registered 468 ohms. I also did a continuity test and it showed no continuity. Do either of these tests point to a faulty heater? Idea's? Thanks for your help.

1 Answer

Rob,

If you are reading 486 ohms on the resistance reading of the heater then the heater would not be the problem. The Control board would be the issue and would need to be replaced.

Read More...
David for Model Number RS2545SH

Had a problem, it started 2 weeks ago. Fridger temp wasn't stay @ the ideal temp. as 36 it went up to 58 it didn't come down. - Freezer's just working fine! I plugged out for a day and plugged back, it went back to working @temp 36. A few days ago, exactly same problem happened again and this time seemed moter never stop, being noisey. So last night I plugged power out, now it's working again. I think it works as temporary, problem would be back. So can you help for solving this kind of problem?! Thanks.

1 Answer

David,

You will want to pull the evaporator cover that is on in the back of the refrigerator compartment. You will want to check the thermistors for breaks or loose connections and test the thermistors resistance. Also check the heater to make sure that it has continuity. It sounds like you are having a defrost issue and after unplugging for a while it allows it to work again.

Read More...

1 Answer

Hello Joe,

You will want to check to make sure that the evaporator fan motor is running. IF you have impacted evaporator coils then you will want to check for continuity on the defrost thermostat 5303917954 and defrost heater 3206453. If one shows open then replace. If they both check ok then you will need to replaced defrost timer 215846602.

Read More...

1 Answer

Hello Kyle. Based on the information you provided, it sounds like the heater in the evaporator is bad and you will need to order and replace the evaporator assembly DA96-00020Q. The heater is not available separately.

Read More...

1 Answer

Hello Paul. Based on the information you provided, it sounds like the evaporator assembly DA96-00020Q is bad and will need to be replaced. The heater is made inside it and can only be replaced with the assembly.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google