Ta May 25, 2021 for Model Number W10884390 How do you adjust the amount of ice made in a Whirlpool icemaker W10884390? It makes ice, I just want it to make a higher level in the tray. My old frig had an attachment at the end of the arm for adjustment
David May 11, 2021 for Model Number MFC2062DEM00 Maytag Refrigerator MFC2062DEM00; Ice Maker part # 10469286 not working (compatible with Whirlpool AP6030643). The ice maker was working fine until I left the freezer door ajar overnight; then shut it. Melted water collected in the freezer bottom then froze after the freezer got cold again. Freezer still works but - No ice. YouTube says to test the ice machine cycle by jumping port T (thermostat) to H (Heater) with freezer light off. The cycle did not start. I tested port L (Line) to N (Neutral) for AC current. There was none. There is no ice in the water supply hose for at least 7 inches. Why would the ice machine break under the described conditions? Since the cycle did not start and there is no AC detected, is it safe to assume the ice machine is broken and there is no other obvious reason for no ice (solenoid perhaps?)? Thanks for your assistance
1 Answer David, it would be recommended that the wires going from the ice maker to the wall are tested for 120VAC from the black wire to the white wire on the end close to the wall. If there is voltage there when the door switch is pressed in, the failure is in the ice maker harness WPW10458985. If there is not voltage, the failure would likely be from the freezer door switch W11396033 failing or having a loose wire. Read More...
Mike May 10, 2021 for Model Number MFF2558VEB8 I have a bottom freezer and the ice maker does not harvest fell sizes cubes and very light harvest. It does make ice but not much. What would my best option?
1 Answer Mike, Normally when an ice maker is not making full-size cubes and not producing much ice then this would be either the temperature in the freezer is not quite cold enough. It should be between 0 and 5 degrees. Check to make sure that there is not low water pressure and make sure that the fill tube is not freezing over. If all this checks ok then the icemaker would be the issue. Read More...
Joe April 18, 2021 for Model Number W10884390 (AP6030643) How do I take off the front cover of the ice maker? Thanks.
1 Answer Joe, on the bottom, you should find a slot that a screwdriver will pop the front loose. Read More...
Thomas March 02, 2021 The ice maker has been working well for a number of weeks since installation. Overnight it seems to have stopped mid harvest and won't continue. I was able to take the ice out by hand (it was basically standing up), but the make won't seem to continue. Is there something to troubleshoot or should I unplug the unit and plug it back in to see if it resets?
1 Answer Thomas, if the model number of your appliance could be provided in a new question, this will allow the most accurate information to be presented. Read More...
Thomas February 01, 2021 for Model Number WRF535SMBM00 I ordered the ice maker replacement AP6030643. I installed yesterday and nothing is happening. I replaced the make in kind, plugged in the unit. The arm, upon arrival, was not connected to anything on the "drive" side. I assume it goes in the small white circular section of the "drive" side. The arm does not go down very far, perhaps I am doing something wrong?
1 Answer Hello Thomas, yes, the bail arm connects to the backside of the module assembly, the icemaker is set by the manufacturer to be about 3/4 through the cycle so that once connected and powered it will finish the cycle and power the water valve so yes the bail arm will not be in the full down position. Lastly, on your model the ice maker is only powered through the freezer door light /interlock switch, the switch has to be held in or door closed to power the ice maker. Read More...
Jeff Pierce January 13, 2021 for Model Number WRB322DMBM00 I had to replace my ice maker recently, bought replacement installed, nothing stored in ice bin and ice bin kept in original location. Now ice maker will not stop making ice unless manually lift arm up to locked off position.Any ideas or suggestions?
1 Answer Jeff, If the icemaker is not shutting off without putting the arm up then this would be an issue in the icemaker itself. Read More...
Shopteacher October 11, 2020 for Model Number WRB322DMBW Does the replacement Whirlpool ice maker part # AP6030643 for Refrigerator WRB322DMBW have a water level adjustment?
1 Answer Shopteacher, This ice maker does not have a water level adjustment screw. The ice maker is filled off of a timed fill . Read More...
Edwin September 15, 2020 for Model Number W10884390 Installed new ice maker yesterday and it started making ice in just a few hrs. Made 5 or 6 ice drops the haven’t dropped any ice in probably 10 hrs. Whirlpool freezer settings are 1 to 7 and its set at 4.
1 Answer Hello Edwin, check the freezer temperature is 0-5 deg, the ice maker wiring connections are secure, the door is closing the light switch fully, there should be ice in the ice maker's mold, if its dry there is a water fill problem. Read More...
Larry August 13, 2020 for Model Number KBFS22EWBL7 Just watched your video on how to change thermostat on ice maker. There was no mention of turning water supply off first. Do you need to, or is there some kind of check valve ythat shuts upon removal of unit?
1 Answer Hello Larry, the water valve is opened electrically by the ice maker during a harvest/fill cycle. Normally not necessary to shut off the water for icemaker repairs. Read More...