Phil L. June 09, 2011 for Model Number KitchenAid Refridgerator KTRC19MCKL00 My refrig works fine. The ice maker works fine. Three weeks ago the ice smells like an moldy odor and just smells awful. Does the ice maker have a filter that needs replacing? The water in the house tastes and smells just fine. Thanks.
1 Answer Hello Phil! The model number supplied, KTRC19MCKL00, does not match any models in our records. Most refrigerators do have water filters that needs to be changed at least every 6 months. Please double check your model number and resubmit. Thanks. Read More...
Ernie J. June 08, 2011 for Model Number ksrs25qgal01 Is there a replacement for the plastic housing in the ice bin that covers part of the ice auger?
1 Answer Hello Ernie. All parts for the housing are available for this auger. I believe the part you are referring to is part 28, the drum 4388736. I will include a link to the diagram in this message. I hope this info helps!http://www.appliancepartspros.com/partsearch/model.aspx?model_id=250660&diagram_id=28209626#d28209626 Read More...
Dean&Dog June 05, 2011 for Model Number mzd2766geb How do I adjust the freezer door for a better fit? I am on a well 35*on 40* off is there an adjustment to let more water in? Cubes are shallow at one end. Last, if a defrost heater has good continuity can the element still be weak?
1 Answer Hello Dean&dog. To adjust the freezer door, you will need to use the hinges and leveling legs. Make sure the unit is level. If not use the screws behind the toe panel to level the refrigerator. You can loosen the screws on the top of the freezer door hinge and move the door if needed. If the unit is not letting in enough water for the icemaker, you can remove the cover from the icemaker. There is a white plastic adjustment screw on the side of the icemaker module. Turn this screw for more or less water. If the heater shows continuity, it is good. The heater does not always glow red. Hope this helps. Read More...
Karen June 04, 2011 for Model Number ET1CHMXKQ03 Icemaker water is overflowing onto the freezer bottom?
1 Answer Hello Karen. If you disconnect the fridge from the power outlet will the water stop flowing or continue? If it continues, you will have a defective water valve WP2315576. Most of the time the overflow of the icemaker is due to a defective water valve. This answer was located on our Repair Forum, this is a free service in which technicians will assist with answering repair questions for our customers. Please use this link to assist in your repair: http://forum.appliancepartspros.com/refrigerator-freezer-repair/176534-icemaker-overflow-removal.html . Hope this helps! Read More...
Vicki June 04, 2011 for Model Number hmg19149 My ice maker is making ice very slow. Sometimes it take 2 hours to make ice, and sometimes it doesn't make ice all night. The temperature in my freezer is correct, and the water fills to the right amount.
1 Answer Hello Vicki. Based on the information you provided, it sounds like the icemaker D7824706Q is bad and will need to be replaced. Hope this helps. Read More...
Sid June 03, 2011 for Model Number frig is psd267lhes and the ice maker has an Im#s 106 626640 The tray fills with to much water it over fills but it does stop. Tried adjusting it turned the screw 2 times 1/2 turn each time had same results both times. During the cycles both times after removing the water each time jumping the t & h on the front to make it cycle there was a spark each time comming from behind the white wheel on the front for just a couple of sec. It still rotates good and goes through the cycle.
1 Answer Hello Sid. Based on the information you provided, it sounds like the icemaker D7824706Q is bad and will need to be replaced. Hope this helps. Read More...
Taras W. June 01, 2011 for Model Number AP4135008 and AP4427021 Ice maker was working with a broken bail arm. The arm simply wasn't attached because the plastic broke. It would either make too much ice or no ice at all then stopped working all together. Thought the problem would be solved with a replacement ice maker. I first checked to see if the ice maker was getting any power which it wasn't. Replaced the ice maker and waited 48 hrs and still no ice. Checked the new ice maker for power and it wasn't getting power either. I tried all of the different test points using a multimeter for both ice makers. Then decided to try a new wire harness. But that didn't change anything. I also checked that the water valve wasn't iced over or clogged. I can fix just about anything but I stuck on what to do short of calling in a repair guy. The fridge is only about 3 years old and there are no other problems with it. The fridge is made by Amana model number ARB2557CSR. What should I do next?
1 Answer Hello Taras. If you supply your email address, we can send you the service manual for the refrigerator. Hope this helps. Read More...
Kevin May 31, 2011 for Model Number Amana ARB8057CSC Following up on your response to my earlier question... How can I see if the water in the water tube supply line is frozen? Is it simple to pop out, thaw and replace? Thanks.
1 Answer Hello Kevin. You will need to remove the icemaker and look inside the fill tube and see if it is frozen. Also you can remove the water line from the fill tube on the back of the refrigerator and cycle the icemaker to see if water comes out of the line. If so, the fill tube is frozen. Hope this helps. Read More...
Tom May 31, 2011 for Model Number AP2984633 Icemaker was working great and then it started taking over two hours to complete a cycle (ice dump.) The freezer temp is fine and the water is being supplied as required and freezing within an hour.Could this be an intermitent thermostat? The ohms check of the thermostat is satisfactory, which would make sense since it is still functioning all be it slowly.This is a replacement unit that I installed about 2 years ago.
1 Answer Hello Tom. If the icemaker is not cycling properly, you will need to replace the icemaker 4317943. Hope this helps. Read More...
Kevin May 30, 2011 for Model Number Amana ARB8057CSC My water dispenser inside my Amana bottom freezer fridge works fine but the icemaker quit making ice. The refrigerator is about 7-8 years old. Is it time to replace the icemaker and which part number would I need? Thanks.
1 Answer Hello Kevin! Check to see if the icemaker is filling with water. If it is not, check to make sure that the fill tube has not frozen. If the fill tube is not frozen, test and replace the defective water valve. If the ice maker is filling with water, make sure the freezer is freezing properly between 0-5 degrees. If the freezer is ok, replace the ice maker D7824706Q. Hope this information helps! Thanks. Read More...