Range Gas Conv Kit Parts

Location: Right rear.

Natural gas. SM 1.07mm

Liquid propane. Main burner

This orifice is the small, calibrated gas jet used in the oven burner to control natural gas flow for proper combustion and consistent heat. It replaces a worn or clogged orifice to help restore reliable oven ignition and baking performance. What it does:

• Directs and meters natural gas to the oven burner for correct flame size and stability
• Helps resolve symptoms like weak or uneven burners, weak ignition, or yellow/sooting flames when caused by a restricted orifice
• Used on the oven top/burner assembly where a #38 sized jet is specified
• Fits into the burner orifice holder and works with the existing regulator and valve

• Install only after shutting off the gas supply and following all safety procedures; check for leaks with a soapy water solution or approved leak detector
• Use correct tools and avoid damaging the orifice tip; thread carefully to prevent cross-threading
• Do not modify the orifice; replace with the exact specified size to maintain safe operation

This orifice is a replacement gas jet sized for a stovetop top burner to deliver approximately 8,000 BTU when used with liquid propane (LP), helping burners light and burn evenly. It's a direct-fit service part for compatible ranges and cooktops. What it does:

• Controls gas flow to a single top burner to produce the correct flame size for LP operation
• Restores consistent ignition and steady flame when a burner is weak or won't stay lit
• Helps maintain proper cooking temperatures by metering fuel to the burner
• Used when converting a burner or replacing a worn or damaged orifice

• One top burner orifice (8K, LP)

• Installation requires removing the burner cap and unscrewing the existing orifice; use appropriate fittings and tools
• Turn off the gas supply and power to the range before servicing; work in a well-ventilated area
• After installation, check for leaks with a soap solution and confirm proper ignition and flame characteristics

This LP conversion kit lets a compatible gas range or cooktop be converted for use with propane (LP) fuel, restoring safe burner performance after changing fuel types. Use the kit to adapt fuel delivery and burner settings for LP operation. What it does:

• Reconfigures burner fuel delivery for propane so the appliance operates on LP instead of natural gas
• Provides the parts needed to change orifices and adjust pressure flow for LP-compatible combustion
• Helps correct symptoms like poor burner ignition, low flame size, or uneven heating when set up for the wrong fuel
• Supports safe, manufacturer-recommended fuel conversion when installed correctly

• LP conversion kit components

• Installation should follow the manufacturer's conversion instructions exactly
• Turn off and disconnect the gas supply before beginning work
• After installation, test for leaks and verify proper burner ignition and flame characteristics

This orifice is the small gas-fitting that meters fuel to a range or cooktop burner, helping maintain the correct flame for safe, even cooking. Replacing a worn or clogged orifice restores expected burner performance and heat control. What it does

• Meters and directs gas from the valve to the burner for proper combustion
• Helps maintain an even, stable flame and consistent heat output
• A clogged or damaged orifice can cause weak, uneven, or noisy flames
• Correct orifice sizing is required for safe burner operation and efficient cooking

• One orifice

• Turn off gas supply and power to the appliance before servicing
• Replace only with the exact orifice specified for your appliance
• After installation, check all connections for leaks using a soap solution or a gas leak detector

LP orifice / size #93 (9.5k)

A replacement bake ignitor assembly that provides the hot surface needed to ignite the oven's gas burner for consistent baking and broiling. Replaces a worn or cracked ignitor to help restore normal oven heating. What it does:

• Heats to a high temperature so the oven's gas valve can ignite the burner
• Common symptom: oven won't heat or take much longer than normal to preheat
• Common symptom: burner fails to light even when controls are set correctly
• Works with the oven's safety and gas valve system to allow reliable ignition

• Disconnect power and shut off the gas supply before beginning any repair
• Handle the ceramic ignitor tip carefully; avoid touching it with bare hands
• Verify proper electrical connector and mounting fit before final installation