Range Support Parts

Right-hand end plate for electric ranges. Replaces cracked, bent, or corroded exterior panel. Restores proper support and alignment to side components.

Left side end plate for electric ranges. Replaces cracked, broken, or missing end panels that provide structural support and finished appearance.

This support smoke eliminator bracket secures the oven/range smoke eliminator assembly so it stays aligned and helps channel smoke and cooking vapors away from controls. It restores correct mounting and reduces rattling or misalignment during use. What it does:

• Secures the smoke eliminator/smoke baffle assembly to the appliance frame
• Helps maintain proper airflow path to reduce smoke and odor reaching controls
• Prevents movement or vibration that can cause noise or misalignment
• Common symptom: visible sagging, loose bracket, or rattling near the smoke eliminator area

• One smoke eliminator support bracket

• Disconnect power to the appliance before starting any repair
• Requires basic hand tools; access may involve removing oven door or rear panels depending on model
• Inspect surrounding fasteners and the smoke eliminator for damage; replace as needed

Rail base support plate for ovens and ranges. Mounts underneath oven racks to provide stable support. Replace if cracked, broken, or missing.

This instruction plate is the replacement control-panel label that restores readable operating instructions and markings on your appliance's control area, improving usability and reducing guesswork for users. What it does

• Replaces a cracked, faded, or worn instruction plate so control markings are legible again
• Identifies control functions and basic operation steps at the appliance interface
• Helps reduce user error by restoring visible labels and icons
• Maintains the original appearance of the control area

• Disconnect power to the appliance before servicing to avoid shock or injury
• Remove any fasteners or trim holding the original plate; this part installs using the same attachment points
• Handle carefully to avoid scratching the printed surface during installation
• If adhesive is used on your model, retain or replace any adhesive backing per the original configuration