Room Air Conditioner Parts

A small flat washer used as a replacement fastening spacer that helps secure bolts and prevent metal-to-metal wear. Restores proper spacing and fastener tension so assemblies stay aligned and tight. What it does:

• Acts as a spacer and load-distribution surface under a bolt or nut
• Prevents fasteners from loosening and reduces metal wear at contact points
• Restores correct alignment where a missing or worn washer caused vibration or rattling
• Simple, durable replacement for worn or corroded washers in mechanical assemblies

• Disconnect power before servicing electrical appliances to avoid shock
• Use appropriate hand tools; replace with the same style and thickness for correct fit
• Inspect mating fasteners and surfaces; replace any damaged hardware

Motor seal for air conditioners. Replace if you notice air leaks, reduced cooling efficiency, or moisture around the motor. Verify fit with your model number.

A small mounting nut used to secure components and panels on compatible appliances. Replaces a loose or missing nut to restore stable, safe fastening and reduce rattling or wobble. What it does:

• Secures panels, brackets, or assemblies to the appliance frame
• Prevents fasteners from backing out during normal operation
• Helps stop rattling, vibration noise, and loose-fitting parts
• Restores proper alignment for attached components

• Disconnect power and water before beginning any repair
• Match threads and size before installation; hand-start the nut to avoid cross-threading
• Tighten securely with the correct socket or wrench, but do not overtighten
• If the original fastener was damaged, replace the mating bolt/stud as needed

This cap clamp secures a wire terminal cap or boot to appliance wiring, helping keep electrical connections stable and aligned for reliable component operation. It's a small but important retainer used where terminal caps are present. What it does:

• Holds a protective cap/boot onto a wire terminal so the cap won't slide off during use or vibration
• Helps prevent loose connections that can cause intermittent operation or arcing at the terminal
• Keeps wiring organized at terminal blocks and component connectors
• Useful when a worn or damaged retainer allows caps to shift or expose metal contacts

• Disconnect power to the appliance before inspecting or replacing wiring components
• Use needle-nose pliers to fit the clamp over the cap/terminal; avoid pinching wires
• After installation, restore power and verify the related component powers and operates normally

Fix an air conditioner that won't start or cycles on and off frequently with a new compressor overload switch. Direct-fit part for room AC units.

Replacement touch pad for air conditioner control panel. Needed when original pad is worn, cracked, unresponsive, or buttons are faded or damaged.

This control base is the main console housing that holds and supports the oven/range control components, delivering a stable mounting surface for switches and the control board to keep controls aligned and protected during use. What it does:

• Provides the structural mounting for the range/oven control board and user interface
• Protects control electronics and wiring from heat, grease, and physical damage
• Keeps control switches, knobs, and displays properly positioned for reliable operation
• Helps reduce vibration and movement that can cause intermittent control faults

• One control base/console housing

• Disconnect power at the breaker before servicing to avoid electrical shock
• Handle control electronics carefully and avoid touching circuit contacts or components
• Some cosmetic trim or fasteners may need removal to access the control base; follow OEM disassembly steps