Roper Dishwasher Parts

Secures the cup shelf to your dishwasher's upper rack. Replace this clip if it's broken, cracked, or missing to keep your cup holder stable and secure.

Dishwasher making loud grinding noise or not draining? This pump and motor assembly circulates wash water and drains the tub. Moderate DIY repair.

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

This is a small plastic or rubber fitting that secures the power cord where it enters the dishwasher's junction box or base. It prevents the electrical wiring from being pulled, kinked, or damaged by absorbing tension on the cord. Replace this part if it is cracked or missing, which can leave wiring exposed and vulnerable to damage during installation or use.

Wire harness elbow connector for dishwashers. Replaces damaged, cracked, or broken electrical connectors that route power between components.

Seals the rear of the dryer drum to prevent hot air loss and ensure even drying. Replace when worn, cracked, or causing noise. Verify fit by model.

The Dispenser Cover Kit is an OEM replacement part for  Whirlpool dishwashers. It includes both the outer lid that protects the detergent and rinse aid compartments as well as the latch mechanism securing it closed. This dishwasher dispenser kit included the cover, lid hinge pin, spring, snap, and latch.

Causes of a bad dispenser cover can include wear and tear from frequent use, physical damage from accidental impact, and discoloration or warping due to exposure to sunlight or heat.

Symptoms of a bad dispenser cover kit include:

• Cracks or breaks in the cover
• Discoloration or yellowing of the plastic
• The cover not fitting securely or becoming loose
• Difficulty in using the dispenser controls due to a damaged cover

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This replacement dishrack restores secure loading and proper spacing so wash water reaches every item. Replacing a bent or rusty rack helps prevent tipped dishes and marks from flaking rust, and keeps loading/unloading smooth when the rack rollers are intact.

• Holds plates, bowls, and cups in place during wash and rinse cycles
• Maintains spacing for spray coverage and drying airflow
• Rolls in and out along the rails when paired with functional rack rollers
• Common symptoms include broken or bent tines, flaking coating or rust, items tipping, or difficulty sliding the rack

• Disconnect power to the dishwasher before servicing
• Open the door, pull the rack forward, release rack stops/end caps if present, and slide the old rack off the rails
• Transfer any reusable accessories from the old rack to the new rack as required by your model
• Slide the new rack onto the rails, reinstall rack stops, and verify smooth travel before running a cycle

Fix water leaking from under your dishwasher with this pump volute. Directs water flow and prevents leaks with integrated seal. 20-minute repair.

includes seal

Upper spray arm with heatseal for dishwashers. Mounts to the upper rack manifold to distribute water during the wash cycle. Replace if cracked or worn.

Vinyl door seal lines the dryer door perimeter to block air leaks and cushion closure. Replace when worn or cracked to restore a tight seal. Verify fit by model.

Color: white. Measures about 3 inches wide by 4 inches high by 10 inches deep.

Fix dishwasher overflows or won't fill issues. This water level float detects proper fill levels. Replaces broken or stuck floats causing drainage problems.

Touch-up paint for repairing chipped, scratched, or rusted dishwasher racks. Brush-on formula restores appearance where coating is worn or missing.